Electronics Forum | Tue Jan 17 17:28:47 EST 2006 | mrduckmann2000
Adlsmt, We had an issue where an Engineer setuo his own passwords on our machine, he was then laided off and nobody knew the passwords. Electrovert gave us the following passwords to try: Electrovert Wave Solder Logon Id Supervisor Password Pass
Electronics Forum | Thu Jan 26 18:28:40 EST 2006 | MikeAJ
An adhesive style cleaner is primarily used as a "precleaner" for bare boards only. These machines are placed between the loader and the printer. The TekNek machines can be best compared to those disposable lint and hair rollers. The same type of rol
Electronics Forum | Sat Jan 28 13:28:15 EST 2006 | eeltec
Dear All: I am learning to program a Philips Comet GEM Machine with VIOS. I am programming a simple PCB that has 300 components but just 3 part numbers so I want to build a complete board in each table of the machine (A and B) and until now I have no
Electronics Forum | Mon Jan 30 03:42:49 EST 2006 | daxman
Thanks for the reply fellas, I spent all day today working on these machines, and indeed, this is bizzare. The main line was in production, and the placement was excellent on the CP6. I transferred a reel (400 parts per board) to the CP4 and the p
Electronics Forum | Tue Jan 31 11:57:40 EST 2006 | aj
i would agree with taking a closer look at the fiducials. I have the same line config. here but have to say that I have never experienced any conflict between machines. One thing I have seen before is when we ran a particular product on the machine
Electronics Forum | Wed Feb 01 12:57:51 EST 2006 | wheels_in_the_well
There are several makes of stencil cleaning equipment. The previous post mentioned, Aqueous Tech (www.aqueoustech.com). Others of long standing high reputation are EMC Global (www.emcgti.com), Austin American Technology (www.aat-corp.com), and Tech
Electronics Forum | Wed Feb 08 21:02:31 EST 2006 | alphaman
I am with a low volume hi mix CM. We have always taught our pick & place manually on the machine. We now have a newer auto programming machine but for many reasons (not uncommon for CM's) I do not have access to the original cadd data to get the ca
Electronics Forum | Thu Feb 23 09:59:09 EST 2006 | SIR
We have an AUREL CS1222 machine to measure the thickness of the solder paste deposited on a bare board by a stencil printer. This device has a laser beam that has to be put on the pad where you want to measure the solder paste thickness. The measure
Electronics Forum | Thu Mar 02 04:24:46 EST 2006 | walbone
Hi, We have recently purchased a Quad IVC 115 pick and place machine but are finding it difficult to place SOT23 and similar components. The Visual alignment system rejects the components. We have manually measured and also got the system to measure
Electronics Forum | Thu Mar 02 08:37:15 EST 2006 | walbone
Thank you very much. I swapped the component length and width measurements in Autoprogram and it now places the SOT23's with image verification no problem. As for the 0402's I am still working on this. Pick and place is very new to me, well I start
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477