Electronics Forum | Mon Nov 11 15:58:26 EST 2013 | hegemon
We use Koh Young for Solder Paste Inspection. Has been in steady use for over 5 years. Reliable and effective. Would buy the machine again. I receive no benefit from any company listed above. 'hege
Electronics Forum | Tue Nov 19 11:15:11 EST 2013 | anilthaker
Hi I am new to this machine and just started looking into its operations and menus. Does anyone know how to create an Operator on the Main Menu?
Electronics Forum | Fri Jan 31 12:03:24 EST 2014 | markhoch
I can vouch for Keith. I've worked with him in the past on the exact two machines that Bill referenced. Keith is a fine old chap, who was very knowledgable and helpful!
Electronics Forum | Mon Nov 25 11:55:39 EST 2013 | emeto
Hello all. I am looking for a belt feeder for my Siemens machines. Who is making good belt feeders? Please list some companies that manufacture these.
Electronics Forum | Wed Nov 27 13:07:07 EST 2013 | processman
Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc
Electronics Forum | Thu Dec 05 02:43:49 EST 2013 | haiae
Hi, You just take out motion board, clean it & connector on the interconnector board. After done plug in and boot the machine again, it'll be fine back.
Electronics Forum | Wed Dec 18 15:16:16 EST 2013 | edmneb
Anyone familiar with the Research International Microflo 11 Series ovens? Having an issue with the machine not loading Status.dat at startup. Any ideas? Thanks!
Electronics Forum | Thu Dec 19 09:01:04 EST 2013 | bestglobalsmt
same exact mother board and processor 1GHZ advantech p3 what is best way to contact you? email or ? my phone doesn't work good out by the machine.
Electronics Forum | Thu Dec 19 09:11:32 EST 2013 | dekhead
E-mail: either link from dekhead.com, or from smtnet forum link. s/n of machine will help. www.dekhead.com
Electronics Forum | Mon Nov 17 01:36:18 EST 2014 | leeg
I have figured it out from a basic optimising point of view, still struggling with some aspects of the software. Is there a way of fixing the setup as it is so we can just produce a setup sheet to reflect the program in the machine?
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477