Electronics Forum | Fri Aug 06 12:36:37 EDT 2010 | ooskii
dman97, There is a calibration procedure. It is fairly straight forward and will take about 30 minutes. When you reset you machine both of the squeegee mounting blocks/fixtures should be level with each other. Just slide you finger over the fron
Electronics Forum | Thu Sep 02 10:50:21 EDT 2010 | eezday
I'm bringing a GSM-1 machine at a university back to operational condition. I have a project created and I'm experiencing that when it's loaded the PWC goes to a location that is about two inches too narrow. When the PWC is manually told to go to a
Electronics Forum | Wed Oct 20 07:59:34 EDT 2010 | gallionc
After 16 years in the industry, I have honestly never heard of putting wax in a solder pot. Anyway, I do have some experience with Treiber wave solder machines, and as I recall, the air-driven pumps are a nightmare to service. First of all, make su
Electronics Forum | Mon Jan 10 18:08:29 EST 2011 | eadthem
vpblf I actually installed the Uniserver (apache mysql php) WAMP on the AOI machine and there is a setting to make it generate HTML board results, cant remember where off the top of my head. anyhow anyone in the inspection area can now open firefo
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Fri Nov 05 11:30:53 EDT 2010 | deanm
We have a Quad QSV-1 pick and place machine that has performed fine for us with the exception of cylindrical glass (MELF) type diodes. The machine often fails to pick these out of the tape to the point where it is easier to hand place them. As far
Electronics Forum | Wed Nov 24 02:53:50 EST 2010 | fönsi
Hello Our company has the opportunity to built a new smt line. we have looked several pick and place manufacturers and their machines. In the end, it will be the decision between two Samsung Modules (SM421) or two different MyData Modules (MY100SX a
Electronics Forum | Wed May 25 17:56:24 EDT 2011 | rssimmons
The SimmScope is an first article inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator t
Electronics Forum | Mon Jan 10 18:50:24 EST 2011 | eadthem
We have 2 universal instruments lines 1 with 120spindle and 11 spindle and another with 30 and 7 spindle. our old line was the 120 and the 7. I was wondering if anyone knows of a easy way or a program that can merge runfiles from 2 or 3 machines so
Electronics Forum | Tue Jan 18 10:46:31 EST 2011 | tombstonesmt
I recently wrote a program on one of our Pilarhouse Jade machines and receiving an error. The machine has the feature of "Wave Height" that I don't have enabled for a 2.5mm extended tip nozzle. This is the only program that I haven't used this featur
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477