Electronics Forum: magnetic (Page 1 of 23)

non magnetic smt resistors

Electronics Forum | Wed Feb 02 08:39:33 EST 2005 | David N Nadel

Looking for non magnetic 1% surface mount resistors. Does anyone have a clue where to find them?

smt magnetic board supports

Electronics Forum | Fri Mar 11 10:00:22 EST 2005 | ???

Anybody out there know of a good (2nd) source to purchase single magnetic board supports used on quad/samsung machines. These are spring loaded and contact the underside of the board in the pick n place machine

non magnetic header pins

Electronics Forum | Wed Feb 02 09:59:10 EST 2005 | David

tring to find non magenetic surface mount header pins

smt magnetic board supports

Electronics Forum | Fri Mar 11 10:51:29 EST 2005 | mfoster

Samsung Back-up pins available from Dynatech for $30 each. http://www.DynatechSMT.com

Magnetized Support Block

Electronics Forum | Wed Mar 27 19:54:25 EST 2002 | ianchan

So does it mean Magnetized Blocks, are not going to be a concern for magnetized machine tables? or are not going to generate electro-magnetic fields? can anyone please help unravel this pop-quiz question? (keeping in mind the support block has rathe

Why can my bare PCB be magnetized?

Electronics Forum | Mon Jan 29 12:09:55 EST 2018 | fluxgate

I am working on a magnetic sensors design and noticed that my measured magnetic field bias shifts over time. I have studied the bare PCB and measured that it can be magnetized with a strong magnet. I tested two blank (unpopulated PCBS). The first PC

Magnet Fields v.s. Electronics

Electronics Forum | Sun Jan 25 15:07:14 EST 2004 | davef

No one handling floppy disk should have a magnet on his or her wrist or in their work area. Furthermore, those with a magnetic paperclip holder on their desk should not allow floppy disks to come in close proximity to it. Since only technicians handl

Magnet Fields v.s. Electronics

Electronics Forum | Mon Jan 26 21:28:55 EST 2004 | Dean

If this is in regards to the manufacturing floor: I can remember years ago I had an Fuji IP3 + MTU4. Used square magnets to hold tray stacks square to the machine. Manufacturing manager told me they should not be used. Apparantly the magnetic fie

LED Stick To Cover Tape

Electronics Forum | Wed Jul 07 10:17:33 EDT 2010 | flipit

We have this problem only with one manufacturer of LEDs. Avago LEDs give us the problems where SunLED and KingBright do not. We put a magnet under the embossed cover tape. The magnet is mounted to the feeder. Holds the part in the tape pocket. L

Magnets in the bottom of CP6 feeders ?

Electronics Forum | Tue Dec 05 06:40:09 EST 2006 | cyber_wolf

You are probably right about the oven fumes, but there are indeed magnets in the bottoms of some of the feeders.

  1 2 3 4 5 6 7 8 9 10 Next

magnetic searches for Companies, Equipment, Machines, Suppliers & Information