Electronics Forum | Wed Jul 13 14:24:43 EDT 2011 | leemeyer
Look at http://www.habasit.com. They sell the belt and the tools to cut and join the ends. I remember looking into this several years ago and the cost of the tooling was so high that it didn't make sense for us to make our own belts.
Electronics Forum | Mon Oct 31 02:36:01 EDT 2011 | kenmar
Thanks , If you reduce the placement precision the X-Axis does not make any noise but than I had placement /pickup problems when it comes to Ic's.Slowing down did not make any difference.
Electronics Forum | Fri Oct 26 13:43:54 EDT 2012 | whispell
Make sure your machine configuration is correct. You may have something assigned to the machine that is no longer there. For 24V check to make sure all of the E-stop jumpers are plugged in.
Electronics Forum | Mon Apr 01 10:15:22 EDT 2013 | babe7362000
I have to agree with you. We do go by piece rate not by time. Also who is supposed to make a process, the Man.Eng., or the lead? I would think the Man. Eng and the lead should make sure everyone is following it?
Electronics Forum | Mon Jun 10 08:13:48 EDT 2013 | bobpan
Check to make sure the side covers are closed. It is probably an interlock problem. Also if you have carts...make sure the plunger switches are down. Good Luck
Electronics Forum | Fri Sep 13 06:48:51 EDT 2013 | JB
Hello, anyone know whats wrong with our Pick & Place machine? we have a Samsung CP40CV and on head 3 its is getting a lot of vibrations and makes the full head vibrate, sometimes it make a noise from the vibrations.
Electronics Forum | Wed Oct 22 14:55:00 EDT 2014 | rrosera
Does anyone have any experience with labels capable for withstanding both re-flow and machine wash cycle? We've tried a few different materials and the ones that make it threw re-flow wash off and the ones that make it threw was tend to melt in re-fl
Electronics Forum | Sun Aug 09 15:25:17 EDT 2015 | dev88
dear sir i am new for aoi section,my work will be teaching of aoi defect and related to programming, want to know how to make program easily in mirtec 4.1.1 and what are the different standard which we must understand.
Electronics Forum | Thu Aug 20 15:00:35 EDT 2015 | scotceltic
A few other items that will help. Make sure your PCB has good support inside the CP8 and always make sure your paste registration is dead nuts.
Electronics Forum | Wed Feb 01 11:38:07 EST 2017 | emeto
It is hard without specifying the models and the options on them. These are two of the top manufacturers out there, but there are even better, so if you are going to make a mass production assemblies, you should make a much bigger research.