Electronics Forum | Sat Jul 08 20:11:20 EDT 2006 | Dick Koriska
I was once like that, worked for a major telecom manufacturer, couldn't design my way out of a paper bag, and now I'm making wooden pallets. My latest project is analysing the forces required to drive a nail into a plywood wooden pallet.
Electronics Forum | Fri Jul 21 12:08:48 EDT 2006 | fabione
Thank you so much. today i've had the offer.Siemens is the hightest. Mydata ,simulation of my products, work about 16000 19000 with 2 hydra.Siemens 18000 21000. I love change over with agilis, but now i must explain all my sensation to boosses. I mak
Electronics Forum | Thu Jul 20 12:05:44 EDT 2006 | vikkaraja
Hi there to all, I have noticed one of my cp is making very loud thumping sound from the table lately. This noise is only from X-axis not the Y at all. Here are the following things that I went through so far: checked if this was due to lack of lub
Electronics Forum | Fri Jul 21 12:28:56 EDT 2006 | jdengler
You say you are new to SMT. If no one at your facility has SMT experience you will want to get equipment that comes with good support and excellent training. This can be difficult with used equipment. Make sure the equipment you end up selecting h
Electronics Forum | Fri Jul 28 21:58:44 EDT 2006 | Wave Master Larry
All you funny guys and your names. Listen, this is whats wrong with this forum and the world today. Too many clowns making fun of serious buisness. What the hell is POD group anyway. Sounds like some outer space movie to me. Maybe they hung up o
Electronics Forum | Thu Jul 27 11:27:39 EDT 2006 | gregcr
Hi All, Wondering if anyone is using this Autosplice CC-112 Pin inserter. We have one here and I am wondering if there is offline software or a serial communication spec that is used to load programs in from a PC. We can make changes on the unit i
Electronics Forum | Mon Jul 31 14:46:08 EDT 2006 | Chunks
Hi Russ, Wow, just Chempolished ah? These stencils are electropolished, so I would think they would release pretty easy. Ours are 6 mils, ut I don't think that would make a big deal though. I'm talking a nite and day diff between jobs. I guess a
Electronics Forum | Tue Aug 01 10:09:52 EDT 2006 | cyber_wolf
Chunks, Make sure your aspect ratio is OK. Normally for an application like this, I would use a .005 foil. The foil material would be invar.The invar has better release characteristics. Crappy solder paste can also cause release issues. I am not sur
Electronics Forum | Tue Aug 01 12:38:13 EDT 2006 | razor9114
I would go with a 5 mil stencil as well, we experienced some similar issues with micro BGA's and the area ratio was suspect as well as the MESH size of the paste. We went to Type IV paste and verified our area ratio and everything ran beautifully. Pa
Electronics Forum | Tue Aug 01 15:02:06 EDT 2006 | BillB
Had a Treiber in a past live. Had a standard air knife in the first section and then a turbine blower with a stainless steel air knife with about 15-horse motor. Had some problems with bearing on the turbine Make sure the exhaust hot air doesn't con