Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Tue Dec 05 14:51:00 EST 2000 | JAX
Nick, In siemens terms: Fuji has the ability to check "ink spot" which I assume is what you are doing now. The only difference is the vision capabilities between the two machines. You do not have the freedom of siemens type gray scale with Fuji. Yo
Electronics Forum | Tue Dec 05 14:56:16 EST 2000 | JAX
Nick, In siemens terms: Fuji has the ability to check "ink spot" which I assume is what you are doing now. The only difference is the vision capabilities between the two machines. You do not have the freedom of siemens type gray scale with Fuji. Yo
Electronics Forum | Thu Nov 30 16:23:42 EST 2000 | Michael Parker
Hello Reno- Rather than capitalize with expensive equipment and spend a lot of time teaching yourself the right way to process, have you considered finding a Contract Manufacturer to help you? A good CM who specializes in New Product Introduction (N
Electronics Forum | Thu Nov 30 23:48:16 EST 2000 | DL
Dave, Thanks for the input. I cant beleive I didnt think to check the suppliers web site, I feel like an... well anyhow. The leads I'm referring to are place at a 90 degree angle from the edge of the pcb and extend towards the bottom as opposed to
Electronics Forum | Tue Nov 28 18:10:13 EST 2000 | Michael Parker
Norman- I would be pushing to get the real world to match the ideal world, in other words get your jobsetters to do the right thing. You are looking to incur more costs to justify not having to make people do their job right. A bit of training a
Electronics Forum | Wed Nov 29 10:50:24 EST 2000 | blnorman
Vacuum casting (same process used to make solid rocket motors) should remove any air from the paste. We had thought of pressurizing the tubes to remove the residual paste, but that would entrap air. The problem of tubes sitting out for different
Electronics Forum | Wed Dec 20 09:41:52 EST 2000 | blnorman
Ideally we want to mix the same lot numbers in a repackaged tube. Once again, these are partial tubes that have been thrown away. If the ratio is right to begin with the only change would be due to air exposure. Semco makes a TC seal which, if we
Electronics Forum | Sun Nov 19 16:01:18 EST 2000 | Dean
Hi Friend. I recently went through this same project in my factory. Initially, I spent quite a bit of time out on the lines (6) collecting data. After getting an overall idea of where and what the activities were I created forms and work instructio
Electronics Forum | Sun Nov 12 17:35:40 EST 2000 | Darby
George, You need to calibrate your chucking assemblies! . What you are seeing is poor alignment due to egocentricity in you jawing assemblies. Also make sure that your jaws/nozzles are in good condition and that your assemblies are correctly orientat