Electronics Forum | Mon Jan 04 10:02:25 EST 2021 | djwave
Hi Aharper, We have an EKRA E5 too and starts to do this error "machine offline" like yours. I chequed like you say, the SMEMA ports, but seems all is good. You can send me the service Manual if you have it?, any clue on that error you can explain m
Electronics Forum | Tue Jan 05 07:01:37 EST 2021 | djwave
Hello, thanks for your replys. Our EKRA E5 only boots and use the front computer (old PC with MSDOS and software), the rear one always is off, dont start when i switch machine power, dont know if is required for operate the EKRA. We turned on the EK
Electronics Forum | Wed Sep 04 13:40:46 EDT 2019 | smrsteve
Hello DWL, Thanks for the response. I've measured the components with a micrometer and set the sizes. Maximum tolerance on my machine is 20%, and that's what I'm using. If I do a manual scan, the measurements are exactly right (and what I've set up
Electronics Forum | Wed Jan 08 19:16:56 EST 2020 | spoiltforchoice
http://suddendocs.samtec.com/literature/em_tectalk8a_lr.pdf Even so its still a fairly manual process so I guess you really have to want to use this type of connector because its a whole process in itself and I bet the whole family is a special or
Electronics Forum | Mon Jan 27 13:47:44 EST 2020 | dnachristen
The DEK Gridlock system should have rubber pads on top of the metal posts. We had them in our old Dek machines but upgraded to the fully automatic ones on our O3iX machines (Grid Lok) The manual ones can be tricky to set up and requires you to have
Electronics Forum | Mon Jan 20 03:13:34 EST 2020 | silverlead
Included screenshots from DEK manual, outlining stencil depth adjustment. Basically, distance from rear of the stencil to the front of the image is value needed to be set on scale when positioning stencil. There is an other way to adjust stencil, by
Electronics Forum | Thu Jan 23 08:31:44 EST 2020 | dontfeedphils
I've had to order the PCB and stencil from aftermarket sources in the past, but I can't find the info anywhere on the stencil/hole grid. All I have is this manual. I believe I actually rented the PCB/stencil from PPM, then ordered my own replacemen
Electronics Forum | Wed Jan 22 11:18:26 EST 2020 | emeto
It is all PCB design based for me. Auto router is great as you can pick tabs locations to avoid stress on components close to the PCB edge. For some boards you can hardly justify anything other than manual V-score. So I would say there is no better w
Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?
Electronics Forum | Fri May 22 06:35:36 EDT 2020 | joost
No i dont have a manual for a Assembleon Emerald, if anyone can find one that would be a big help! also when i open the Optimizer there are very limited things i can do with it, i can tell it to have feeders in set position and tell it where to prio
