Electronics Forum | Wed Feb 16 09:44:09 EST 2005 | beta
Check to see if its the same component everytime if so check part height . Also check Z0.This setup is in the manual. You say this only happens after maintenance is carried out so when you free the nozzle it doesnt happen again until maintenance is
Electronics Forum | Mon Feb 28 16:04:30 EST 2005 | Alex
I use to have that kind of problems with other type of machines and here are the causes: 1- Spray fluxer head partially obstructed (check flow rate) 2- Defective pre-heater probe (manually check temps) 3- PROFILE (last preheat to 280) 4- we sometimes
Electronics Forum | Tue Mar 29 09:54:20 EST 2005 | chon
Indy, Please refer to IPC-TM-650 TEST METHOD MANUAL Number 2.4.21.1, this is the closest written procedure I've found and used for this. I hope helps or if someone has any other input please advise. On more thing I have this file just let me know if
Electronics Forum | Sat Apr 09 18:33:08 EDT 2005 | valuems
Hello If mr. Miller will go to the dos promp ( esc key ) and type in dir/w and then open the .000 file he will find the pass words. As far as the UP100 goes, god only knows. Forget finding this in the manuals. And I should add the .000 file is a su
Electronics Forum | Wed Apr 13 18:28:21 EDT 2005 | RT
We have a situation where our customer returned a device (BGA) with a missing solder ball. The process is Copper-Nickel-Gold-Solderball. EDX revealed that no trace of gold nor solder material (lead-free balls). Could poor Au plating/adhesion cause
Electronics Forum | Fri Jun 03 05:31:21 EDT 2005 | grantp
Hi, Yes, and I mean to update that old thread. Things are working really well now we have changed over. Looking for a buyer for the MYDATA now, and we are going to unload the vapor phase and manual printer, and some long conveyers. Need to add it al
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Thu Jun 23 03:43:45 EDT 2005 | ajaydoshi
Hi Jerry, > > Thanks for the info. Is vision > number required for the IP3? From the manual it > appears not (needed for IP1 & 2), however vision > type is required. > > Thanks, Dave We are using IP3 & placing BGA. BGA part data only for outer
Electronics Forum | Wed Jul 20 16:51:48 EDT 2005 | Pete Roy
My Dek printer "forgets" the speed setting after a few passes and reverts to a faster speed thus screwing up the print. If you edit and change the programmed value and save it, all remains find kind of like refreshing the memory. Any suggestions, I
Electronics Forum | Thu Aug 11 17:07:47 EDT 2005 | pjc
First off, your Hollis pot cannot withstand a SAC305 no-Pb alloy. Could corrode in as little as three months of continuous use. To "de-lead" you drain the pot, clean as much manually then flush with Sn. The wave user or your solder supplier typical