Electronics Forum | Sat Jun 22 05:40:36 EDT 2013 | lkavan
Hi friends, I am sorry that I boring you again, but I hope somebody can help me... I have a problem with servodrivers Panasonic MSD5A3P1EA in my Tenryu MT5530. Some servo loops are unstable, motor is shaking. It is problem with driver, when I change
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Wed Aug 07 15:41:28 EDT 2013 | simplycomplex85
Absence of solder is just black/super dark red which still falls under any percent I could put in there. So it passes. Maybe I'm a bit confused on how the machine checks solder in general anyway... 0%-60% is a pass by default. Thats anything dark - s
Electronics Forum | Thu Aug 08 11:28:34 EDT 2013 | simplycomplex85
I found a manual for a slightly newer version of my machine and it explained some of the terms that I wasn't familiar with. That helped. Also it seems a slightly newer version of the YTV-2000 series has TH built right in. Mine just doesn't. I playe
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Mon Jun 16 10:52:02 EDT 2014 | robstarrs
bobpan quick background. I am very new to the Quad machines, I used to "run" one, but I never learned the inner workings of a machine. I just purchased 2 used quad 4cs, I had a training session over the weekend with a very knowledgeable guy and l
Electronics Forum | Tue Oct 22 16:30:50 EDT 2013 | joeherz
Dear Lord, We have had similar challenges with customer requirements related to ionic testing. You have determined that you cannot get a reliable result from testing at the stage where the adhesive has been applied. That option is out. Assuming
Electronics Forum | Thu Nov 21 20:23:26 EST 2013 | dandin87
We have a Speedline MPM UltraPrint 500. The Hard drive currently in it has bad sectors, and so I had tried to install a new hard drive and used the installation folder from the old one to re-install SigmaPro 32. When I start it fails to find the Mete
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Mon Feb 24 12:57:33 EST 2014 | mi
Import->Part->Library Import PD wizard Menu->Import->to Job->BOM (adds P/N only to assembly but does not go into Parts Library) etc. Among all these tools, they each prompt for different files with different name & extensions & format. I've trie