Electronics Forum | Tue Apr 30 17:13:11 EDT 2019 | kahrpr
I was at the show in San Diego. The Hanwah HM520 is wicked fast and half the price of the other major manufactures. Full disclosure we own Samsung/Hanwha but not that model.
Electronics Forum | Tue May 28 02:09:47 EDT 2019 | robl
Back in the day when everyone had turret chipshooters we used to see a lot of cracking due to incorrect z heights, especially where customers swapped between manufacturers.
Electronics Forum | Thu Jun 27 09:47:11 EDT 2019 | capse
I represent ECD, They manufacture the SmartDRY series of dissicator storage cabinets. Nitrogen costs can add up if you are in and out the cabinets during a shift. Info here; http://www.ecd(dot) com/
Electronics Forum | Thu Jul 18 13:14:04 EDT 2019 | emeto
From your post I would say send your board to a contract manufacturer and don't worry about it. NC process is preferred method overall, unless there is a special requirement for Water wash.
Electronics Forum | Wed Jul 31 00:47:32 EDT 2019 | nikyta
There is a lot of Asian manufacturer who can answer your question, I'm sure it won't take long to be heard .... ;)
Electronics Forum | Sun Oct 06 06:54:48 EDT 2019 | sarason
And what do you mean by commercial? Chinese hit/run adds for Circuit board manufacturers? A sutble plug after I have answered a users question and have sometimes even written code at my time and expense to solve their problem? Sarason Author of P
Electronics Forum | Wed Oct 09 17:58:56 EDT 2019 | SMTA-Joe
I'm not sure there is so much of an advantage as much as it may be just easier to apply? New to dispensing, especially in this application, so I'm mainly brainstorming at this point. I will look into the manufacturers you listed though. Thanks for
Electronics Forum | Wed Oct 09 10:16:48 EDT 2019 | valletta
Hi, I am new to PCBA manufacture and would like to ask the experienced users whether it is normal to have 100% visual inspection in the industry? Or is AOI and ICT testers if programmed correctly enough? Thanks in advance David
Electronics Forum | Mon Oct 28 20:25:23 EDT 2019 | sarason
Is it a single membrane switch or part of a panel. If single, chase down a similar type, if part of a panel you may be able to go back to the manufacturer for a replacement panel. Otherwise drill a hole and install a replacement unit being careful to
Electronics Forum | Mon Nov 18 20:30:39 EST 2019 | alanyang
The chip resistors are placed on the edge of the board, but the board has no or enough waste tabs. When de-panelizing, the bits may contact and break them. You can use a smt carrier, or add waste tabs in your next assembly manufacturing.
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400