Electronics Forum | Thu Oct 26 18:43:09 EDT 2000 | Christopher Noonan
I am looking for tooling plate manufactures. I am kind of new to the SMT process, well as far as tooling goes, and I am trying to find a machinist to make tooling plates for Fuji and Siemens placement machines. Does anyone have any recommendation f
Electronics Forum | Mon Oct 23 21:05:37 EDT 2000 | cklau
If you're looking for PWB cleanliness , please consider one surface treatment other than HAL (i.e HRF-heat resist flux). HRF is a very inexpensive and effective process that your board manufacturer can provide you to meet your requirement. For gold
Electronics Forum | Mon Oct 16 11:53:35 EDT 2000 | Howard C. Ohlhous
I would like to know what type of glue is used to hold down surface mount devices to boards before/during solder reflow. I would like to obtain said glue for evaluation and possible use in an assembly procedure. Please Advise: What company manufactur
Electronics Forum | Thu Oct 12 12:59:06 EDT 2000 | jackofalltrades
Does anyone know of a manufacturer of a Small Bench Top Convection Oven that could be used to reball BGAs? Right now we use Winslow Preforms and an Air-Vac DRS24 or our reflow ovens, but this ties them up too much and I'd like to keep reballing seper
Electronics Forum | Wed Oct 04 16:17:08 EDT 2000 | Brian W.
I would be happy to share some insights with you, but would prefer to do it off line. I have been involved with CM work for 9 years. Please feel free to e-mail me a phone number or e-mail address if you would like to speak about it further. Brian
Electronics Forum | Thu Sep 28 14:36:45 EDT 2000 | James
We dump the paste in with the dross in a 55 gallon drum. It's all hazardus waste the only difference is paste has flux and dross is who knows what. We use waste recycler. I don't know if we get as much money back as you would from the manufacturer
Electronics Forum | Thu Sep 14 11:19:59 EDT 2000 | Brian W.
It really isn't that difficult to control. Have one of your mechanical or manufacturing engineers design a quick little fixture. We used to have the same problem, then we designed a two piece fixture out of aluminum. We also had our own tape and r
Electronics Forum | Mon Aug 28 15:59:43 EDT 2000 | Tom Humphrey
Can any one give me a list or recommendations of board assembler / manufacturers (Southeast U.S. prefered) who could handle assembly of 2 inch x2 inch PWB with 100+ surface mount components. No testing required. I would appreciate any help or recomen
Electronics Forum | Fri Aug 25 00:15:15 EDT 2000 | Wilson
Hi all, Does anybody meet large size of tape cavity in 0603 components? It is a serious problem in some vendors that their tape tolerance is very large. It lead to our fallout rate abnormal high. What is standard tape cavity size? Why the componen
Electronics Forum | Mon Jul 24 11:10:38 EDT 2000 | Sal
we have just started manufacturing a board which has surface mount components on side 1 and on side 2 all the thro hole components are d type connectors, (loads of them) the chances of these connectors inserted with the wrong orientation is very, ver
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400