Electronics Forum | Thu Feb 24 21:44:27 EST 2000 | Dave F
Horace: Area you in the rainy or the dry portion of the South? ;-) Now, excuse me from mincing words with you ;-) �, but buying a manufacturing software package is a serious (expensive) endeavor that will leave no part of your company unscathed. I�d
Electronics Forum | Tue Jan 23 11:55:27 EST 2001 | aiscorp
I gather from your question that you might have experienced large scale system implementation problems in the past, or at least fear experiencing it in the future. This is a very valid concern based on the performance of traditional CIM systems. Fo
Electronics Forum | Mon Feb 19 13:04:17 EST 2001 | billschreiber
The ultrasonic frequency used in today�s stencil cleaners is usually a 40 kHz �sweep� frequency (also used on semiconductors and other sensitive cleaning applications). This frequency is not low enough to cause stencil damage (the lower the frequen
Electronics Forum | Tue Feb 20 17:30:14 EST 2001 | billschreiber
Dave, I think we are heading toward the same objective, but from different directions. You are asking what's the cost of ownership? However, I think a question that is just as important and one that is pertinent to your current economic picture is,
Electronics Forum | Mon Mar 19 09:20:14 EST 2001 | Stefan Witte
Hi Dave, I may read the �Root Cause Analysis� to get a better understanding what it is all about. My general impression is that the sessions are purposely held short and with a short prior notice. It is not supposed to give you too much time to quest
Electronics Forum | Thu Jun 28 08:14:11 EDT 2001 | Stefan Witte
I visit customers on a contract base to get the machines in a status, that an operator can take over. These customers are usually small shops, who can not effort an engineer to set up the machines. I am not afraid of my job, if it does not require a
Electronics Forum | Thu Dec 23 17:24:18 EST 1999 | Deon Nungaray
Deon Response: Hello Mike, Although the trend now days is to outsource, in some cases building it yourself is a worthwhile process. From what you say your product seems pretty simple and mature, so it might be very cost effective for you to bring i
Electronics Forum | Mon Jan 03 01:15:05 EST 2000 | Jon
Mike, I understand your dilemma very well. You see, I was a manufacturing engineer for 11 years doing make or buy decisions before getting into the sales field. But for this commentary I will wear my engineer hat. Your situation is not uncommon.
Electronics Forum | Thu Oct 21 09:56:11 EDT 1999 | Brian
Rich An excellent question and one which is often totally ignored. If you wish a "no-clean" flux to be as safe as it possibly can be, the PCB and the components must all be contamination free (ionic and non-ionic). Only then can you be sure that the
Electronics Forum | Fri Jul 30 20:11:35 EDT 1999 | Mike Konrad
It is true that the use of saponifiers (and other water soluble additives) will lower the surface tension and aid in under component penetration. It is also true, however, that other specific design features within a batch machine can also aid in un
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400