Electronics Forum | Tue Aug 26 15:39:49 EDT 2008 | kpm135
I am not positive about this but I have been told that you cannot use acrylic and urethane coatings in systems that have had silicone run through them. It was explained to me that you can never fully get the silicone out of the existing system and th
Electronics Forum | Tue Sep 16 10:15:48 EDT 2008 | mw_fl
Would appreciate any input you might have in our search for an SMT line. We are an OEM done our through in house but outsourced our SMT production. We have a couple of new products that are going to be higher volume so we have decided to look into ad
Electronics Forum | Wed Sep 17 11:57:17 EDT 2008 | realchunks
At 250K / month, you may need a few Mydatas. They are great machines but not all that fast. Bottom line, without a BOM, size board or panel size, no one in their right mind can tell you what machine to go with. They can tell you what they like, bu
Electronics Forum | Mon Oct 06 15:17:12 EDT 2008 | davef
Q1: You say that 0.008" of "slop" is un-doable; hence, the reasons for our failures. Any basis for that statement? A1: We're not even considering the accuracy of your placement machine. We base our comments on the gap between the hole and the connec
Electronics Forum | Thu Dec 11 12:17:16 EST 2008 | bmaheu
Setting up a PCB washing "system" and the facilities required for a cost effective and repeatable cleaning process depend heavily on the application (water soluble versus chemistry cleaning), (batch cleaner versus ln-line) and local factors (quality
Electronics Forum | Thu Dec 18 14:54:28 EST 2008 | hegemon
We evaluated OMRON, YesTech and Mirtec. Mirtec and Yestech close at #1 and #2. Omron was a little more distant due to programming time required. We are a high volume high mix OEM builder, so speed of programming was a heavier weighted score than co
Electronics Forum | Thu Jan 22 11:12:06 EST 2009 | davef
Conformal coating masking: Electronic equipment manufacturer's use conformal coating processes to protect printed circuit modules from moisture, fumes, rapid temperature changes and other environmental conditions. Typically, pressure sensitive tapes
Electronics Forum | Sat Apr 04 03:24:41 EDT 2009 | monduran
Our company is in the market to replace the $50 toaster oven we use to reflow boards with something that can actually achieve even temperature and a proper reflow curve. We are a RnD type company and have no need for volumes. Though we have some heav
Electronics Forum | Wed May 13 17:01:09 EDT 2009 | stevek
A lot of the problems with very small proto runs is that there is little profit in it. It seems to be getting worse with small start ups with no configuration management, half baked documentation, and no concept of manufacturing, pushing on proto sh
Electronics Forum | Thu May 14 10:50:14 EDT 2009 | dnachristen
Hello, New to the site here. Have a few questions regarding Philips (Assembleon) Equipment and program transfer. We need the ability to transfer "Golden Programs" to and from the machines. I'm currently using AMS 2.0 with line control. I hooked up
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400