Electronics Forum | Wed Sep 05 12:11:03 EDT 2001 | seand
Hello Michael, Laser marking and ink jet marking are now offered by a wide array of suppliers. The was a bit of a boom at APEX last year in the number of suppliers for these systems. Many have tried label placing but have run into a number of conc
Electronics Forum | Thu Aug 29 06:48:01 EDT 2002 | yngwie
I have seen several Imm Ag pad on the assembled board which have a copper colorleaching through the silver plating This happened on the pad which was not deposited with paste during the assembly process. Don't know if it is a problem, but we only
Electronics Forum | Sat Dec 02 11:35:30 EST 2006 | davef
Best dross remover is to not produce dross. Search the fine SMYnet Archives for previous discussions Dross will not increase signicantly * Another story, that lead-free solders will generate a greater volume of dross than conventional materials, is
Electronics Forum | Thu May 29 00:26:58 EDT 2008 | bobwillis
Bob Willis' Top Ten Reference Books Here is a new list of "Bob Willis' Top Ten" reference books that has been updated for 2007 to take into account recent changes in technology. In the publishing industry there are many charts and awards for the bes
Electronics Forum | Fri May 18 10:43:32 EDT 2012 | davef
Umar Chapter 7 of IPC-HDBK-830, Guidelines for Design, Selection and Application of Conformal Coatings deals with compatibility of the different materials in the chain. Have you: * Tested your bare boards at incoming for cleanliness with your Omega
Electronics Forum | Wed Jun 03 07:13:27 EDT 1998 | Tom Tellinghuisen
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Tue Jun 02 17:36:43 EDT 1998 | Chris Fontaine
| | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not
Electronics Forum | Mon Feb 01 09:17:45 EST 2016 | spoiltforchoice
You can buy an awful lot of stencils for $200K > but where/how are you going to store all of those > stencils? There is a certain $$$ value to all > the space it will take to store them. > > I have > been told by a Mycronic salesman that they a
Electronics Forum | Wed Jun 03 15:22:12 EDT 1998 | Greg Curler
| | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not
Electronics Forum | Tue Jun 02 18:01:47 EDT 1998 | Earl Moon
| | | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is no