Electronics Forum | Wed Jan 05 18:31:30 EST 2005 | russ
It is possible to re reflow (is that right?) these assemblies. You will probably have to mask off or remove the through hole components if they cannot withstand the reflow temp. I would recommend however, that you utilize a hot air process to ins
Electronics Forum | Tue Jul 26 11:02:30 EDT 2005 | dphilbrick
I have a single sided PCB that contains 4 RF connectors that will require conformal coating. Sounds easy, well the RF connector is .080 in diameter and stands a whole .050 in height. The sub-straight that the barrel sits on is about .020 thick. I don
Electronics Forum | Tue Aug 16 08:01:20 EDT 2005 | davef
Peter: Questions are: * From your pictures, the white residue appears to be only on the solder mask. Is that correct? If not, what is the location [eg, solder, nonsolder/nonmask areas] of the residue that doesn't show well in the pictures? Further,
Electronics Forum | Wed Aug 24 21:57:45 EDT 2005 | adeline_ko
The blistering is around the plugging via. I can forward you the pic. For the plugging process, I'm not too sure how they plug. What is the correct practise for the plugging via. Now, what they did is. They will do a tenting process for both side.
Electronics Forum | Mon Sep 19 09:02:10 EDT 2005 | clampron
Good Morning Everyone, We have a customer that produces RF based assemblies. We are building several board types for them, all of which have an "RF" area of the PCB. This RF area does not have any mask to define pads. There are also several issues w
Electronics Forum | Mon Oct 03 12:22:54 EDT 2005 | Stew
Depending on your application, you may need to pre-heat before Soft Beam (unless they make one for it now). Plus, very small connections seem to push it's limits. The beam can only get so narrow. Lasers are good but reflectivity can come into play
Electronics Forum | Fri Oct 07 09:18:39 EDT 2005 | russ
If you're using non-lead free parts then you don't have a pbfree assembly so why worry about marking it anyway? We apply this artwork after the assembly has been completely engineered for lead free. Artwork can be covered up with mask or whatever if
Electronics Forum | Tue Nov 15 14:31:59 EST 2005 | Samir Nagheenanajar
Back in the days when I was in charge of a Paintline Dip conformal coater, I had the same issue with a non-hermetically sealed Potentiometer. We tried to use rubber boots, but the capillary/wicking action of our silicone-based heat cured coating was
Electronics Forum | Wed Dec 07 07:20:02 EST 2005 | davef
We need more information about the situation. For instance: * Describe the green residue * Talk about the distribution of the problem, including a single lot or from various lots and over components and component types on the board * Tell us about t
Electronics Forum | Tue Feb 28 11:07:41 EST 2006 | Chunks
Gel Flex works for Dek, just a slight modificaion. Works 100% better than any Grid type of system. We had missprints from Grid Lok and Form Flex - about every 5th or 6th board. Until we modified the Gels, we would take the time and some peelable s