Electronics Forum | Fri Jan 24 09:58:41 EST 2020 | pavel_murtishev
Evtimov, There is no solder mask at all. Material is applied over bare aluminum. Regards
Electronics Forum | Mon Apr 27 12:22:36 EDT 2020 | emeto
Is your board spending 40s on a molten solder at 500F?
Electronics Forum | Mon Apr 27 12:30:02 EDT 2020 | mvargas
That's correct. This is because the component (switch) needs to be removed and soldered on the wave.
Electronics Forum | Mon Jul 26 17:57:50 EDT 2021 | cyber_wolf
Place a label and etch that instead of the PCB. Too many variances in solder mask
Electronics Forum | Mon May 02 04:40:57 EDT 2022 | 1_manuel
Hi there, thank you all for the advice. I will look into that! :)
Electronics Forum | Fri May 27 18:43:19 EDT 2022 | SMTA-64387182
Thanks for confirming. Joe
Electronics Forum | Tue Nov 22 02:38:30 EST 2022 | davef
What type of material is your solder mask?
Electronics Forum | Tue Oct 03 18:11:58 EDT 2023 | glasscake
Scalpel, audio book or a podcast. if you have a micro bead blaster that would be faster
Electronics Forum | Wed Feb 16 21:51:29 EST 2000 | Dave F
Kurt: Lots of choices, not many of them good, yano. 1 So LPI has taken over the market pretty nearly 100%, but it won't "tent" reliably, because it is not very viscous when applied and drops into the hole. So then, tenting/plugging with LPI is bad
Electronics Forum | Wed Feb 16 21:51:29 EST 2000 | Dave F
Kurt: Lots of choices, not many of them good, yano. 1 So LPI has taken over the market pretty nearly 100%, but it won't "tent" reliably, because it is not very viscous when applied and drops into the hole. So then, tenting/plugging with LPI is bad
