Electronics Forum | Tue May 18 03:23:56 EDT 1999 | PhilB
Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) Did some of you guys did some testing on both types and what were your findings
Electronics Forum | Tue May 18 18:17:50 EDT 1999 | Scott Cook
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Mon Nov 25 00:45:35 EST 2013 | igorfo
Thank you for advice, But main concern how to detect the problems with BGA on SMT line, and how I can validate "good" or "bad" profile. PS: SPC said that process Cpk 2, temperature profile in the upper spec limit for TAL and peak temperature.
Electronics Forum | Sat Nov 23 08:05:20 EST 2013 | emeto
Hi, I would check the thing in the following order. 1. Check paste - SPI is the best way. If you don't get the right deposit there is no wonder you have issues. 2. Check reflow profile - tweak it to the point of perfection for the board you have. 3
Electronics Forum | Fri Nov 22 11:31:52 EST 2013 | igorfo
Hi I aa QE on SMT line that produce products for Home introduction. No so long ago we have a problem with soldering of BGA Head on Pillow (root cause mismatching customer requirements and BGA profile spec, suplier change %Ag) and our product affect
Electronics Forum | Fri Nov 22 16:55:30 EST 2013 | hegemon
Head and Pillow defects beneath a BGA are difficult to find, no matter what the equipment is on hand. Since you do not appear to have access to tools that would help you, or $$ to purchase said tools, I might recommend that you use an outside source
Electronics Forum | Mon Nov 25 18:43:29 EST 2013 | hegemon
Without the proper tools in house you will not be able to determine anything but the most obvious problems. At minimum, some side looking microscope that would allow visual inspection of a row or two, and to be able to rule out bridging. Using that
Electronics Forum | Wed Nov 17 14:58:04 EST 2010 | otipicni
Hi everybody. I need to calculate the moment of inertia of a pcb (with its components) and also its center of mass. The pcb is not manufactured yet. Before that I need to verify those properties. How could I do? The pcb will weight around 50 g. Shou
Electronics Forum | Fri Jul 07 16:56:21 EDT 2017 | jchris
Defective LED's that I need to replace.
.jpg)