Electronics Forum: mcs30 and monitor (Page 1 of 7)

mcs30

Electronics Forum | Wed Sep 21 02:58:33 EDT 2005 | ajay

we are using MCS30 for fuji line. Now monitor is giving some problem. we can not replace it with normal monitor. this monitor is with key board. any solution to connnect with normal monitor ? ajay

mcs30

Electronics Forum | Wed Sep 21 04:21:46 EDT 2005 | Rob

I'm sure there is also memory in the monitor.

mcs30

Electronics Forum | Wed Sep 21 07:10:05 EDT 2005 | aj

Hi, Can you not source a replacement monitor?

mcs30

Electronics Forum | Thu Sep 22 02:43:35 EDT 2005 | jgarver1

Which model of monitor do you have?

MCS30 system and printer

Electronics Forum | Wed Oct 28 11:38:00 EDT 2009 | andoe

Does anyone know how to get a printer to work with an MCS30 system. I have limited information about printer setup.

MCS30 system and printer

Electronics Forum | Mon Nov 02 07:59:32 EST 2009 | shannond

Contact Greg Frazier at Automated Technology Services, he may be able to help you. He's been fixing my Fujis for a long time. greg.frazier@ats-smt.com

IP1 and SSOP28

Electronics Forum | Tue May 18 16:40:22 EDT 2010 | m79d

I am having some problems getting the IP1 to place a SSOP28 package,pitch 0.65mm lead width 0.3mm. I am selecting computer vision 012 (tried 011) and vision type 100. EL data was put in looking at the datasheet and also measuring the device. Have tri

IP1 and SSOP28

Electronics Forum | Tue May 18 21:43:02 EDT 2010 | ashley

Hello mickd, 1) The EL data & Vision_type is NOT necessary when using MCS30 for IP1 machine. note : your input of the above might have cause confusion during VP, hence the OS error. 2) I would suggest the following... 2a) lower the Lead_check_are

MCS30 operating system and Fuji user interface info?

Electronics Forum | Tue Oct 20 17:30:15 EDT 2009 | rodrigo

Hi all, We use the IMF converter (and a floppy disk) to move programs to and from the MCS30. The only way to get to the command line in the MCS30 is to reboot and do the ctrl+shift+_ ketpresses. I wanted to try to add an entry to the Fuji User inter

SPC and Wave

Electronics Forum | Thu Jul 14 11:04:53 EDT 2005 | dougs

yes SPC can be used on a wave solder machine, you should use a c-chart to monitor the amount of defects per board or group of boards, this will let you know if your process is stable, as you improve your process you should re-calculate your UCL, hope

  1 2 3 4 5 6 7 Next

mcs30 and monitor searches for Companies, Equipment, Machines, Suppliers & Information