Electronics Forum | Thu Dec 29 10:54:29 EST 2005 | DannyJ
Hi PFI, Sorry, the owner probably will not go for shipping the bug. We have 4 plates here, but only one bug for the dip and one for the VCD's. I'll do my best to get you the information needed, though... The part # is DIP-561 and is $500 USD fro
Electronics Forum | Wed Feb 01 08:27:29 EST 2006 | Chunks
I haven't seen a hydrometer used in years. Are you still foam fluxing? There used to be automatic units available, but with the advent of the spray fluxer, they may have dried up. If you are still foam fluxing with alcohol thinner, place ping pong
Electronics Forum | Mon Feb 13 09:18:06 EST 2006 | sumxp
Certain paste mfg specify 6 hours paste thawing time to normalize the temperature. I am using solder paste softerner to spin the paste taken out from fridge for 9 minutes and measure the paste temperature in jar.It is around 26'c(same as the ambient
Electronics Forum | Mon Feb 13 12:41:38 EST 2006 | masrimhd
Hello, I know for sure that using lead-free technology in conventional tin-lead machines makes a lot of problems. But I wonder if we can use conventional tin-lead alloy and components with a lead-free machine! Is it possible? Does this imply any s
Electronics Forum | Thu Feb 16 13:03:52 EST 2006 | Tom Winchell
Assuming the AL tape shorts the wires for the thermocouple, you effectively have three junctions at the business end of the wire: wire 1 to AL, wire 2 to AL, and wire 1 to wire 2. If the temperature of the junctions wire 1 to AL and wire 2 to AL are
Electronics Forum | Wed Feb 22 08:01:42 EST 2006 | INGE
We have a new SMT line, our customers are asking us the validation of the process. Not only the validation of the resulting assembled board (solder joint...) but also a validation of every single machine in the line (ex. stencil printer...). For exam
Electronics Forum | Thu Mar 16 14:15:54 EST 2006 | ratsalad
Well I honestly can't say that I have enough flow, so that's a good point. We don't have a flow meter or manometer on our reflow exhaust. How do you measure that? Or, is it just that you make sure your exhaust path is clean and the blower is wor
Electronics Forum | Sat Mar 25 16:05:13 EST 2006 | loz
Hi, sounds unusual if your profile is accurate that you have so many residues. Had a similar problem before with no clean flux and with various flux manufacturers, and all residues were down to excess flux. This does not help your case though. How a
Electronics Forum | Mon Apr 24 15:11:11 EDT 2006 | pjc
For solder joint inspection you cannot beat AXI. That's what is was designed for. AOI machines were designed for component inspections and solder joint checking was an add-on. In transmission AXI you can get a measurement of the whole solder joint. A
Electronics Forum | Wed Apr 26 10:34:06 EDT 2006 | slaine
In England all domestic sockets are 3 pin, with an earth. You can quite easily buy a device that plugs into the socket and has 3 press studs on the back that connect to the earth. These are usually made for connecting ESD straps to. I know RS sell th