Electronics Forum | Wed Aug 03 21:00:12 EDT 2005 | rcarlos28
Crishan, Do you check the Nozzle orientation? some machine use a Rectangular o circle nozzle body, and this reduce the vaccum. When this component is taked from the feeder and the camara measured recognized the pins? Do you change the type of rec
Electronics Forum | Mon Aug 22 11:49:59 EDT 2005 | pjc
Fixed spray head performance depends on board width. If you are looking for complete top-side hole fill, the flux penetration into the lead-hole will be more in the center and less on the ends because of the fan pattern spray. For board widths over 6
Electronics Forum | Thu Sep 01 18:27:28 EDT 2005 | Board House
Hi I currently Manufacture product for Dataradio Inc. in Quebec. and would be interested in quoting your product. We are a Multi-layer facility in Minnesota, we currenty manufacture layer counts between 2 & 18 layers. Line widths and Spacing down t
Electronics Forum | Fri Sep 23 06:42:08 EDT 2005 | lloyd
The only issues I have had in the past with the shuttle are 1. The transport conveyor into the machine was not aligned correctly causing pickup issue from the belt. 2. Operators not correctly loading parts in trays or updating the qty's, this meant
Electronics Forum | Sat Oct 29 21:24:30 EDT 2005 | Paul Standeven
The CSM84 family units are 3 headed pick & place machines with mechanical chuck centering technology. They use a beam pointer for fiducial correction. The CSM84V is the same as the CSM84 but has a downward looking fiducial camera onboard in lieu of
Electronics Forum | Wed Feb 01 17:36:37 EST 2006 | Cal Kolokoy
Your method of only using solder paste to form the solder joint w/out collapsing the ball is very unconventional, just as others have mentioned on this thread. I bet you those joints will fail under thermal and mechanical stress. Have you done due
Electronics Forum | Tue Dec 06 18:29:45 EST 2005 | darby
You may also wish to check the speed controllers for both descent and ascent. The higher the ascent speed the more force the jaws close with. It can be difficult to achieve a "good" nozzle placement height as this is mechanically set and your lowest
Electronics Forum | Thu Dec 08 22:15:46 EST 2005 | molosse21
Hi everyone, One of our customer is asking us wich one of these two components has a better resistance to vibration. Vibration can be a potential problem for them. He has the choice between a thru hole radial capacitor with near 0.400 in diameter an
Electronics Forum | Sat Dec 17 02:15:25 EST 2005 | manyhats
Fastek, i believe your right something manual or semi will work great... don't waste time or money buying that fully auto printer, they all do that same Sh&t... i have 2 TP-11 and think you should be ok placing the 0402 using the C14 tool and mechani
Electronics Forum | Thu Jan 05 14:00:40 EST 2006 | Steve
We are currently runing a JUKI 750 and 760 as well as a 2060. I can't say enough good things about the quality of the machines and service from JUKI. I've had zero downtime in the last 2 years due to mechanical breakdown and our machines run 18 hours