Electronics Forum | Tue Feb 24 15:31:44 EST 2009 | pcbrookie
Wrongway - Interesting about the rails. I'll check to make sure operators are leaving a little 'wriggle room' on the rails in case they are in fact getting narrower in the middle. SWAG - I suspected the initial temp. might be a bit hot, thus causin
Electronics Forum | Fri Oct 09 06:53:10 EDT 2009 | taus
Hello, I've recently started to work with MPM AP25, I began doing maintenance to get to know the machine. But now I'm having some problems in the teaching process. You can see the problem in the photo. http://img59.imageshack.us/i/image194p.jpg/
Electronics Forum | Fri Aug 12 08:13:12 EDT 2011 | rway
The only thing I see that might be a fuse is the green vertical axial leaded component next to the third from the bottom white 4-pin header. It's labeled ?718 or 710. I don't know if this is a resistor or a pico fuse. You can try to ohm it out. An
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Tue Feb 07 05:36:30 EST 2012 | ngineer
Yup, that sounds right. I did try one with red > on top on one side and white on top on the other > side. Oops, blew a capacitor out of the back of > the base. If anyone else Has these, here's how > it goes to make them work: Top pin on both
Electronics Forum | Mon May 07 16:07:05 EDT 2012 | davef
Start with targets based on the stencil thickness (for height) and stencil thickness times the aperture size (for volume). * Set reasonable upper and lower control limits (+ 25% and –25 % of the targets, for example). * Next, check the printer set-u
Electronics Forum | Wed Mar 20 13:18:26 EDT 2013 | kmots15
Is printing your concern or placement. I would say both: Printing: At 5 feet and on a flex you better have a really nice fixture to keep everything in check. You'll probably have to hand screen it unless your going to get a dedicated custom continu
Electronics Forum | Wed Jun 12 14:42:40 EDT 2013 | armandogomez
Hello guys ! I am here again with a problem, right now we have a problem with a new product, the problems are with voids with the PTH we put a receptacle with terminal blades that are 1.3mm width in a pth with a diameter of 1.5mm we use a pallet to
Electronics Forum | Wed Jul 24 22:24:07 EDT 2013 | mac5
When we first got our XP1’s the cycle steal was on a schedule. We would have boards running good and then start placing off in the middle of a run. We finally noticed that the cycle steal had run just prior to the parts being misplaced. We have turne
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse