Electronics Forum | Wed Aug 17 07:06:35 EDT 2016 | jdengler
If you cover the first fid of that module the machine will stop. You can then choose to skip the module.
Electronics Forum | Wed May 23 08:39:37 EDT 2012 | tony_d
Thomas, We evaluated several AOI machines and narrowed the field to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. In our experience, the MIRTEC machine simply outperformed the competitive
Electronics Forum | Thu Sep 15 11:18:04 EDT 2016 | cyber_wolf
When you attach multiple modules to the manifold, this is the only one that screws up ? It sounds like something maybe hooked up backwards.
Electronics Forum | Thu Aug 18 09:46:40 EDT 2016 | jbuckley
Put anything over one of the fiducials being used in the circuit, and run the board. It will stop, and on the top right a window will pop up. Click "Skip Current Module" and it will X-out that circuit. If you are using the fiducials on the rail, rath
Electronics Forum | Wed Apr 30 21:00:36 EDT 2003 | davef
ENIG is a common solderability protection on BGA packages. Pd/Ni/Au while more expensive could have advantages over ENIG in the following area: * Allow both gold and aluminium wire bonding * Better solder resist compatibility (63�C max) * Might take
Electronics Forum | Wed Feb 06 13:45:39 EST 2013 | phase1
Is there alot more to training than what the manuals spec out? The machine came with training outlines that seem to be a condensed form for programming everything from chips to fine pitch etc. Im not sure if this doccument came from Mirtec or the com
Electronics Forum | Fri May 17 11:00:57 EDT 2002 | Sam Chiocca
Demand Wave Solutions has an inventory control module, BOSSgoldIC, that can be integrated with your present ERP system or implemented individually on an open architecture platform. It is on-line, interactive inventory management system that provides
Electronics Forum | Tue Nov 20 11:19:07 EST 2018 | spoiltforchoice
Ahh but you're missing the key points. The YSM40 is in no way ever intended to operate on its own, to keep those 4 heads busy they all need to be placing high volume parts, combined with a high throughput of PCB's probably in dual lane mode which in
Electronics Forum | Tue Jun 23 22:19:33 EDT 2020 | kumarb
Hi. Have an older 1809EXL that was purchased new and has sat idle for years with 270 on hours as of today. After days of testing, unable to melt fresh paste from Loctite (SAC305). The root cause after the investigation is due to one of the 2 TDM modu
Electronics Forum | Wed Nov 28 05:54:04 EST 2018 | robl
You need to look at what other smaller companies are using, the KY machines usually go in multiples into large installations. I've seen a few places with 1 or 2 machines but they are usually running volume of very few board types. In these environm
