Electronics Forum | Fri Jul 03 18:46:16 EDT 1998 | Jon
Yes, but at what price for the 'fast ' system???? | | | Help!! | Sorry, I missed the insert portion before. Contact me, I have a high-speed system capable of measuring a 12" x 12" pcb, all pads, in under 20 seconds. | | There has to be someone out t
Electronics Forum | Thu Jun 25 16:13:05 EDT 1998 | Mike McMonagle
I am looking for a little enlightenment with an issue that we have been seeing. We have SMT assemblies with poor solderability on TSOP and mini-QFP type devices. The solder appears to have incomplete reflow and/or grainyness to the joints. Everything
Electronics Forum | Tue Jun 16 23:20:45 EDT 1998 | Scott McKee
| We have a need for a de-taping machine that will take components (SOIC8, 14, 16) from carrier tape and into tubes. Please contact me if you have a system or know of one that we can purcahse. | Thanks! | Diane... Wow, that's a switch; I've been loo
Electronics Forum | Sun Jun 14 11:27:12 EDT 1998 | Earl Moon
| | | To those interested, | | | Earl Moon | What would life be without a bit of change. | Just finished the week at Nepcon East (should be Nepcon New England) What we really need is a good Nepcon east show located so more people would attend the
Electronics Forum | Mon Jun 15 17:49:51 EDT 1998 | Earl Moon
| | I knew there was something or one missing around here. Welcome back. Anything, interesting, earth shaking, or revolutionary East of the "Big Muddy?" | | I often forget I'm there too. | | Earl | Not much, just watching Create KME place 0201's sort
Electronics Forum | Tue Aug 07 21:17:24 EDT 2001 | davef
This provides LT 3 misses /1M hits. * Probe all points on one side of the board. Bonus => This lower fixture cost. * Test pads and vias: GT 25 thou from other land traces. * Small [LT 5 ohm] resistor measurements: Use two pads at each end and do 4-
Electronics Forum | Tue Aug 28 16:07:09 EDT 2001 | slthomas
Just talked to my component engineer. We use the B parts also, and apparently the B suffix indicates compatibility with wave or reflow applications, X is for reflow only. Since we only reflow these parts, sounds like that might be the best route fo
Electronics Forum | Mon Sep 03 23:53:22 EDT 2001 | Poon Man
Hi Jacob, Purchasing high quality magnifier highly depends on your budget. In my experience, rectangular lens is much better than round lens as the view area is bigger. Brightness is very important point to consider. Don�t choose white light. Otherw
Electronics Forum | Thu Sep 06 21:03:29 EDT 2001 | Poon Man
Eric, There are a lot of factors leading to lose components. Suppose your machine works properly. Firstly, is there any gap between the support pins and PCB? If yes, the components may be �dancing� during placement. Have you checked the placement s
Electronics Forum | Fri Sep 07 07:39:11 EDT 2001 | caldon
Can you confirm the components are being picked up from the feeders? If the Feeder table calibration is incorrect the components could be picked up off from the begining. This would result in 1) nozzle barely picking up the part and as the head moves