Electronics Forum | Sat Jul 05 14:07:33 EDT 2008 | shellydhami
Main diffrences in failure modes for mechanically and thermally induced BGA solder joint fracture
Electronics Forum | Thu Jul 10 22:44:54 EDT 2008 | davef
Too complicated to answer. Wudda you say that you post pix and we'll tell you what we think?
Electronics Forum | Fri May 21 12:13:11 EDT 2010 | davef
Failure Modes and Effects Analysis (FMEA): http://en.wikipedia.org/wiki/Failure_mode_and_effects_analysis
Electronics Forum | Thu Feb 21 18:43:35 EST 2019 | dekhead
Are you saying that it works in print mode and not in pass thru mode? Or that is won't pass boards downline regardless?
Electronics Forum | Wed Nov 25 08:23:47 EST 2015 | tercel
Does anyone know how to use the Juki 740 / 750 / 760 in Bypass mode, if the Machine has no parts to place? We use 3 Jukis and for some PCBs it is not neccessary to use all 3 of them. so it would be usefull to use the machine in bypass mode. Is it pos
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Wed Jun 16 14:07:15 EDT 2021 | oxygensmd
For example, I had the same problem on my Rehm oven. It was in calibration mode. The machine is going to maximum transport width but sensor wasn't reached and the machine stucked in calibration mode. Maybe there are manual mode for transport width a
Electronics Forum | Fri Nov 13 07:03:44 EST 2009 | davef
Loco [snip] "The print mode is another consideration. Printers are designed with a squeegee bar and a flood bar. In flood mode the flood bar spreads the paste, and in print mode the squeegee applies pressure, such that the actual printing takes plac
Electronics Forum | Mon May 02 15:36:40 EDT 2011 | marcpeo
One more note on this. The techs tell me that the main reason for the PV immediately matching the Set Point is that the software is in "Edit Mode". This is a mode that allows one to iterate the software without the oven running. That might also ex
