Electronics Forum | Fri Jul 26 19:10:43 EDT 2013 | garym4569
Anyone have experience with any type of aftermarket surface mount reel change verification system that would help prevent an incorrect reel from being loaded? Thanks in advance Gm
Electronics Forum | Thu Sep 12 11:27:21 EDT 2013 | rway
Yes. Typically terminals, large relays, displays, parts with mounted heatsinks. This is typically what you see on hand-insertion lines. Other parts with specialized packaging may not be able to be auto-inserted either. Most axial and radial leade
Electronics Forum | Fri Dec 13 10:06:05 EST 2013 | davef
For vertical mounted, axial leaded components; the standoff from the land to the component body should be 0.4mm[0.016in] to 1.5mm[0.059in]. Right?
Electronics Forum | Wed Apr 16 19:17:11 EDT 2014 | hegemon
OK, POP already done, and you are mounting the POP device. You are seeing opens. Opens at the device/PWB? or opens at the device/device interface? Or possibly both? 'hege
Electronics Forum | Mon May 19 15:13:05 EDT 2014 | davef
Consider this combination: * IPC-7351B - Generic Requirements for Surface Mount Design and Land Pattern Standard * IPC Tools & Calculators [ipc.org/contentpage.aspx?pageid=PCB-Tools-and-Calculators ] * Component fabricator suggestions BR ... davef
Electronics Forum | Tue Jun 24 14:00:58 EDT 2014 | joekirin
We built a tray that accepts tape. It is made out of a waffle tray and board breakaways. It works very well. We use magnets to mount it on our Y-Wagon teaching it as a tray.
Electronics Forum | Thu Aug 28 02:51:01 EDT 2014 | padawanlinuxero
When you say "selecting correct value of the small chip components during assembly", you are referring to caps and resistors? and that you want to know that the correct cap or resistor was place in the correct location? your assembly is surface moun
Electronics Forum | Mon Oct 13 13:24:21 EDT 2014 | rgduval
Deni, Yep, we found that one the other day, too. And, yes, axis mounted is set to 1. We tried setting it to 0, saving, then back to 1 (again, hoping to clear a software flag/fault, if that's what it is). Thanks, ..rob
Electronics Forum | Tue Oct 14 07:38:29 EDT 2014 | dilogic
Z axis drivers are located in co-salled LP servo bay. It is 19" rack mounted in lower left part of the machine. Head1 z axis driver is in slot 4 and head2 driver is in slot 6
Electronics Forum | Tue Nov 04 15:42:22 EST 2014 | rdubya
break-out the old toaster oven! apply solder paste to board place part and re-flow in toaster oven. those things re good for more than just pot pies and toaster strudel.
The SMTA membership is a network of professionals who build skills, share practical experience and develop solutions in electronic assembly technologies and related business operations.
Training Provider / Events Organizer / Association / Non-Profit
6600 City W Pkwy
Eden Prairie, MN USA
Phone: 952-920-7682