Electronics Forum | Thu Dec 05 02:15:12 EST 2019 | sssamw
IPC 2221B mentions a minimum clearance of 0.5 mm between adjacent holes. A drill-to-drill spacing of 20 mils is a standard value in manufacturer design rules. For small annular rings and pad-to-pad clearance, the minimum via distance is often defin
Electronics Forum | Wed Aug 28 19:35:13 EDT 2002 | ppwlee
Hi, Does anyone have guidelines on minimum SMT component spacing for bottom sided wave soldering? I am looking for general rule of thumb in wave soldering bottom side SOTs, 0805 & 0603s. How about minimum through-hole lead to pad distance? Peter
Electronics Forum | Wed Aug 28 19:36:29 EDT 2002 | ppwlee
Hi, Does anyone have guidelines on minimum SMT component spacing for bottom sided wave soldering? I am looking for general rule of thumb in wave soldering bottom side SOTs, 0805 & 0603s. How about minimum through-hole lead to pad distance? Peter
Electronics Forum | Fri Oct 26 05:03:17 EDT 2018 | farouk225
Hi everybody, I have a question about the minimum distance to leave beteween a non non-plated mounting hole with copper pads and the edge of the PCB. Is there any formula or rule to apply ? For example for a hole of diamater equals to 5.6mm which
Electronics Forum | Fri Jun 25 16:32:45 EDT 1999 | MMurphy
| | | hello, | | | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | | thanks for the input | | | | | | wayne | | | | | | | | | | | We have tried this mainly
Electronics Forum | Tue Feb 27 11:03:09 EST 2007 | Marcin
Hi All, Anybody knows what is the minimum clearance between through hole component and chip component? Problem description: On bottom side of my pcb are only 0603 chip components mounted on glue. One of the component is located very close to hole
Electronics Forum | Wed Jun 23 18:23:32 EDT 1999 | Tom B.
Even though you may find a pad-pad thru-hole spacing, part body size, orientation, and insertion head tooling clearences may be the deciding factor in spacing. 1. Part body diameter will dictate component centroid spacing. ---[][][][
Electronics Forum | Wed Jun 23 15:49:30 EDT 1999 | Kelly Morris
In the IPC-SM-782 (Surface Mount Design and Land Pattern Standard) it recommends a minimum of .040" between bottomside wavesoldered chip pads. Where might I find a similar IPC recommendation for minimum space between thru-hole pads? Does anyone kno
Electronics Forum | Mon Mar 13 15:10:52 EST 2000 | Stuart Adams
Assuming agressive design rules what is the minimum distance I can get away with between the board edge and a SMT pad and between the board edge and a plated mounting hole ??? (The board is only 1"x2" and the mounting holes are 80 mil dia, 125 mil
Electronics Forum | Mon Mar 13 15:10:52 EST 2000 | Stuart Adams
Assuming agressive design rules what is the minimum distance I can get away with between the board edge and a SMT pad and between the board edge and a plated mounting hole ??? (The board is only 1"x2" and the mounting holes are 80 mil dia, 125 mil
