Electronics Forum | Fri Jul 09 07:26:57 EDT 2004 | Claude_Couture
On Panasonic equipment are the MPAV feeders compatible with the MPA-80/MPAG1?
Electronics Forum | Fri Feb 24 13:44:16 EST 2006 | yiannis
hi, Can anyone tell me there are the switches that configure the RS232 communication with computer ? thnks
Electronics Forum | Fri Dec 26 13:35:14 EST 2003 | fpcb
hi, When I start a MPA-80 ( NM 2529T ) I have a 4600 error, ( 1 block stop ) , I check the covers and the pressure : all ok. I monitor the head I/O address 012 and the relative bit 6 is responding when I open the covers. All seem ok BUT the error
Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Fri Jan 10 00:56:53 EST 2003 | fastek
You really must be on a tight budget since most people will pay YOU to take these models off their hands. What is your budget for capital equipment? Zero? That said, I think you would be better served to step up a generation and look at MPA-3's inste
Electronics Forum | Fri Feb 27 09:47:45 EST 1998 | Steve Schrader
I am looking to purchase a used 2 foot section of conveyor to install at the output of a Pansonic MPA-80. If you have one for sale, contact me at steve@patton.com
Electronics Forum | Thu Mar 26 10:13:19 EST 1998 | Randall Jacobs
| I am looking to purchase a used 2 foot section of | conveyor to install at the output of a Pansonic | MPA-80. If you have one for sale, contact me at | steve@patton.com
Electronics Forum | Mon Mar 02 21:10:54 EST 1998 |
| I am looking to purchase a used 2 foot section of | conveyor to install at the output of a Pansonic | MPA-80. If you have one for sale, contact me at | steve@patton.com
Electronics Forum | Thu Jan 09 02:29:59 EST 2003 | yiannis
I want to buy a used machine,a cheap one, maily fr FQP chip placement.I think to buy a MPA40 or a MPA80 or a IP1.Which is better ? thanks
Electronics Forum | Fri Dec 26 23:05:29 EST 2003 | tommy
It can be wrong pressure sensor switch setting,malfunction or low incoming air pressure.If incoming air pressure below the setting limit then 1 block stop message will display on screen.
