Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Wed Apr 28 09:43:22 EDT 2004 | Rob
When it comes to double-sided boards, how does one support a board so that those supports don't hit any components on the side already run but yet keep the board firm and rigid? Is it more of an engineering design to layout the board in such a way th
Electronics Forum | Sun May 09 09:23:27 EDT 2004 | Sam
Harry, Yes, the model is AP-20 and the computer is 386. I think the system disk was damaged by floppy driver that did not do the maintenance before reading the disk. I have do the test with the common disk that insert to the driver after do maintena
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Tue Jun 01 05:17:16 EDT 2004 | Alistair MacAdam
I am currently looking at the volume of paste being deposited on a PWB 2.4mm thick with a 0.25mm tolerance. I am looking for information on PWB variation and a MPM AP25 series printer, and can the volume of paste be controlled on varing PWB thickness
Electronics Forum | Tue Jun 01 17:56:41 EDT 2004 | Rob
I got some information on this support mechanism but was a little unsure how it worked. Let's suppose you're getting ready to run the second side, do you place the board on this support and have the support travel into the printer? Or is the support
Electronics Forum | Wed Jun 09 16:54:24 EDT 2004 | Ralf
Hi all I have a question to all of you who has experiences with Microflex MPM. There are two items: one is on contact calibration and second squeegee pressure calibration. Do i have to if i set PCB make these calibration?. Does Microflex have mechani
Electronics Forum | Tue Jul 27 19:37:51 EDT 2004 | simmcircuits
Thank you Paul, this is the actual information I need to adjust the camera! At the moment I have actually reduced the offset values down to 0.7 from a previous 4.0. I have done this by editing the AP.CAL, took a while to get the proper values as I ha
Electronics Forum | Fri Aug 06 21:43:40 EDT 2004 | KEN
In my wiper paper travels I discovered that many different brands are simply "repackaged" from a single manufacturer. Look at fiber size, weave and porosity. In one case two paper were identical, just dyed green. The prices ranged from 26 dollars