Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Tue Jun 05 16:12:51 EDT 2012 | kahrpr
We use both The pin placement works fine for the mpm. If its a dense board you have to to some double checking on the initial set up. On the dek we use Grid lock. For us its toss up which is better they both work.
Electronics Forum | Thu Jun 07 16:27:15 EDT 2012 | swag
Thanks all for the input. We've been to both DEK and MpM for demos and seen the grid-loc in action. Think we'll probably go with that along with our h-towers and dedicated tooling.
Electronics Forum | Tue Jun 19 20:03:16 EDT 2012 | smtventasmex
Hi i have an Accuflex and i enter ones with a pasword to windows, then we writte it down on the equipment and we paint it so we lose the pasword any idea hoy to enter to windows?
Electronics Forum | Thu Oct 04 14:26:45 EDT 2012 | capse
hi, The 2D uses gray scale analysis to calculate area coverage of paste on the pad. Off-line programming was offered via CircuitCAM from Aegis.
Electronics Forum | Fri Jan 04 15:20:04 EST 2013 | dontfeedphils
Any idea where the global offsets are entered? Under the vision setup there are print offsets, but these seem like they would be program specific, which is something we're looking to avoid since we will be running two machines networked. Thanks for
Electronics Forum | Thu May 23 14:34:22 EDT 2013 | dman97
Sounds like you have detent option enabled. Check to make sure that your board X and Y dimensions are correct.
Electronics Forum | Wed May 29 08:47:30 EDT 2013 | zrunkle_api
I'm trying to get into the Calibration section of the machine and don't know the password. I'm would believe it's still the Default password since the maintenance mode is still the Default password "SVC".
Electronics Forum | Mon Jun 03 22:47:10 EDT 2013 | navworx
Thanks MPMENG. Our software is 8.3.3. Has anyone converted to XP (from NT)? What obstacles exist to do this? We'd like the printer on our internal network, where security patches can be applied to the OS.
Electronics Forum | Tue Jun 04 15:16:44 EDT 2013 | smtventasmex
As far i know it is not jut a software modification, this include change on drivers, PS, and some more devices
