Electronics Forum | Mon Jun 18 10:10:56 EDT 2007 | swag
You might try: User (no password) Super "ADMIN" Maint "SVC" F.S. "QMPM" Not sure if these are default but worth a try.
Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Mon Jun 12 10:38:00 EDT 2017 | highmillr
Getting this error more frequently. Whats causing this?? I have to reset machine every time costing man hours. After resetting its fine but does it at least once a day.
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Sun Mar 13 12:45:12 EDT 2022 | poly
Do you have any idea for the Ekra (or any other printer, especially MPM) how many cycles it can do before you should look for a new printer? How used is too used? 1 millon? 2? 10?
