Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget
Electronics Forum | Thu Jul 25 19:18:42 EDT 2002 | lysik
I really would not compare the 2 systems. A ELA is more like MPM's UP-1500. The UP-2000 is more like the DEK Horizon or Infinity. You just opened up one of the great debates of the SMT world. MPM or DEK? You will have people on both sides defend the
Electronics Forum | Mon Aug 26 11:13:49 EDT 2002 | Marco Prince
There is a new tooling invention called the Instant Fixture System. It is a mechanical "cartridge" style dense pin-array system. There is a kit for MPM-UP 2000, and AP Series, and also for DEK-265 platforms. This instant fixture system offers very
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.
Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas
board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin