Electronics Forum: mpm and trackball (Page 1 of 10)

mpm

Electronics Forum | Wed Dec 06 14:06:55 EST 2006 | chrisgriffin

Most MPM's have a DOS operating system only, no windows. Most newer trackball drivers are installed in windows. I haven't had much luck using new trackballs because of this. You can probably find a logitech marble plus on ebay.

mpm

Electronics Forum | Thu Dec 07 19:04:02 EST 2006 | chrisgriffin

Chunks, your right, I need to get out more. What are you doing Saturday night? Harry is right about the software version compatability with trackballs. What is the version and machine type?

SMTECH pro's and con's

Electronics Forum | Fri Oct 05 08:35:29 EDT 2001 | PeteC

I believe this machine is now the MPM UP 100 and is supported thru Speedline Technologies-MPM and is now mfg.'d in Franklin Mass.

MPM Up2000 and SMEMA

Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite

Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas

board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?

MPM Up2000 and SMEMA

Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas

that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.

MPM Up2000 and SMEMA

Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t

Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..

High-end SPI and AOI?

Electronics Forum | Tue Oct 13 08:09:53 EDT 2009 | kudamarani08

Can anyone help me recommend or simulate a SPI and AOI machine that can balance our FUJI NXT 1 with 14 modules. We are using MPM accela printer. 200 UPH is our target. Here's the PCB dimension length(x) = 399.92mm width(y) = 141.626mm Thanks all!

MPM Up2000 and SMEMA

Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas

here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin

MPM Up2000 and SMEMA

Electronics Forum | Thu Sep 15 06:45:26 EDT 2016 | awhite

Hi Ariss_T, Thanks! I actually did check that...that was one of my first thoughts as well. While in the I/O, I slide a raw board back and forth under the camera/sensor and it acted appropriately. I will definitely update this thread as new informa

  1 2 3 4 5 6 7 8 9 10 Next

mpm and trackball searches for Companies, Equipment, Machines, Suppliers & Information