Electronics Forum | Mon Jun 12 10:38:00 EDT 2017 | highmillr
Getting this error more frequently. Whats causing this?? I have to reset machine every time costing man hours. After resetting its fine but does it at least once a day.
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Wed Sep 26 07:59:33 EDT 2012 | benreben
Hi, Someone can tell me what the difference in UP2000 and AP-25? What is the best machine? Thanks
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Thu Aug 17 19:29:54 EDT 2006 | foxhound
Im having problems with my ap 25. I get the air pressure fault alarm when it boots up so I bypassed the air pressure switch but I still get the alarm. The air routes through the machine as soon as I hit the on button, I thought it wasnt suppose to
Electronics Forum | Fri Aug 18 09:29:20 EDT 2006 | chrisgriffin
I would measure the voltage on the yellow wire going to the air pressure sensor. Are you getting 24VDC? If so, maybe replace the input DC module on IO card #2. I think it is IDC module 8 on that board. Try not to have too many violent thoughts.
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Jun 22 12:25:02 EDT 2006 | vikkaraja
and type the following: optedt and press enter.Password for this is QMPM. Good luck and keep us posted.
