Electronics Forum | Mon Jun 12 10:38:00 EDT 2017 | highmillr
Getting this error more frequently. Whats causing this?? I have to reset machine every time costing man hours. After resetting its fine but does it at least once a day.
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Wed Sep 26 07:59:33 EDT 2012 | benreben
Hi, Someone can tell me what the difference in UP2000 and AP-25? What is the best machine? Thanks
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG
Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i
Electronics Forum | Tue Aug 16 22:51:06 EDT 2016 | aemery
Sorry I didn't catch your message sooner! 20k is way to much. The odds of you having 3 bad platens and 3 bad forcer motors would be very unlikely, unless the machine was sitting outside or something. If it is a 10 year old AP then I assume it must
Electronics Forum | Wed Aug 07 13:52:43 EDT 2013 | dlsheeler
AP 36 Schematics no longer needed. Received some from MPM archives. Thanks,
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Thu Aug 04 03:56:38 EDT 2005 | Rob
Hi Danny, I do remember you recently suggested to a customer who was new to surface mount & wanted low volume the following equipment that you were selling: 1. MPM AP25 2. CP4 3. IP2 http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CF
