Electronics Forum: mpm ap25hie (Page 1 of 1)

AP 25Hie

Electronics Forum | Mon Jan 12 17:00:43 EST 2004 | karkanov

Hi, We maybe buy a MPM AP25hie, and the guy who sold the printer told me about a Dedicated tooling and a Universal Tooling...I not quiet sur of what is that, can someone explain it to me and what is the best option. Just for fun are you ready t

ap25 hie

Electronics Forum | Sat Oct 15 19:18:14 EDT 2011 | enttec

Hi Does anyone have a calibration manual for a MPM AP25-Hie ? Have noticed recently that we have a slight mismatch between board and stencil when printing. I have the user manual but we didn't get calibration when we bought this machine Thanks Nic

MPM AP25Hie Pre Board Stop error

Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799

I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst

MPM AP25Hie Pre Board Stop error

Electronics Forum | Sat Aug 04 08:09:03 EDT 2007 | rich7799

I found the problem... the vx cable trunking was the wrong radius, so when the axis was moving at slower speeds to read pre stop position, the axis was not reading the platen correctly due to extra downward force.. Ive now replaced the trunking and

MPM AP25Hie Pre Board Stop error

Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag

Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back

MPM AP25Hie Pre Board Stop error

Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin

When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th

AP 25Hie

Electronics Forum | Mon Jan 12 18:40:32 EST 2004 | fastek

You don't want dedicated tooling. Make sure your machine comes with front and rear dams and plenty of side chucks and magnetic support pins. The best option for these machines is the side snugger option but it doesn't sound like your machine has that

AP 25Hie

Electronics Forum | Tue Jan 13 19:16:03 EST 2004 | pjc

Dedicated tooling uses what MPM calls an "H" tower. You mount the board support plate (dedicated tooling) on top of the H tower. If boards are only single-sided SMT, meaning only components on one side, the board support plate is flat with vacuum hol


mpm ap25hie searches for Companies, Equipment, Machines, Suppliers & Information

Selective soldering solutions with Jade soldering machine

Training online, at your facility, or at one of our worldwide training centers"
fluid dispenser

High Throughput Reflow Oven
Electronics Equipment Consignment

High Resolution Fast Speed Industrial Cameras.
fluid dispensing pumps for integration

High Speed Precision In-Line SPI System - Mirtec MS-11