Electronics Forum | Tue Sep 06 15:13:13 EDT 2005 | Tony
Does anyone know of a company in the San Jose, CA area that can repair MPM screen printers? I am also having reset/zero problem with my MPM printer. Thanks in advance. Regards,
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
Electronics Forum | Mon Oct 31 03:42:47 EST 2005 | pavel_murtishev
Good day, Problem appears only with 0.5mm pitch components. Print quality for these components is unacceptable. Paste type isn�t new for us. No any tape on the bottom of the stencil. We apply enough pressure on squeegees, stencil remains clear after
Electronics Forum | Wed Feb 27 20:49:36 EST 2019 | gonzalo12
Hi I have this communication error on a MPM Acuflex screen printer machine, it power up loads software but when it tries to Zero, it shows a communication error on the screen. Have anybody seen this error?
Electronics Forum | Fri Feb 15 08:13:18 EST 2002 | Dave G
What Snap-Off are you running ? I've seen this happen when a large negative Snap-Off is used. If you "contact" print (I.E. Zero Snap-Off) this tends to minimize the stencil coining. We use a mix of MPM & Transition Automation blades. I have noticed
Electronics Forum | Fri Jan 04 13:47:00 EST 2013 | cyber_wolf
If its the same as a Momentum then no you do not need to use jigs. There is a "global offset" field that allows you to add background offsets. The glass plate jig calibration procedure only needs to be used after a major crash or if you feel the need
Electronics Forum | Tue Sep 22 14:23:42 EDT 2015 | travishemen
We had 4 of these machines several years ago. If I remember right the drive that aligns the board to the stencil was stepper motors with no encoder feedback. We would see the same issue if our leadscrews and linear rails were not clean and properly
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou
Electronics Forum | Thu Nov 03 01:27:10 EST 2005 | pavel_murtishev
Good morning, Our automatic cleaner simply doesn�t clean. When I am inspecting clogged apertures I execute �cycle wiper� command few times. After wiping cycle apertures remain clogged. Zero effect. We tried to use solvent in production to improve cl
