Electronics Forum | Sat Jan 12 15:37:33 EST 2013 | mwac
If the machine is printing with an offset on all products, then yes the printer needs to be calibrated with the fixture. That particular model requires the same tools as the 500 and 1500. They were different from other MPM machines of that or prior
Electronics Forum | Mon Jul 29 08:45:37 EDT 2013 | gallionc
We've been running our ICOM 5000 off and on since it was new in 1996. There's not much help out there for this machine as Stoelting (who bought out Westek) no longer supports it. You might need to replace the filter, which Stoeling can provide, but
Electronics Forum | Mon Jun 02 15:51:17 EDT 2014 | sync40
Thank you so much again davef for your new reply. This past weekend I was looking for more information regarding this subject, but, as you stated there is no information about thioruea concerns during assembly soldering operations, mainly focused in
Electronics Forum | Sun Jun 29 02:50:37 EDT 2014 | alexeis
Hi, The issue is very complex and difficult to arbitrarily divide the types of components. From research we perform today together with our customers to design a work-at-SMT accurate as much as possible, I can summarize that vast time differences de
Electronics Forum | Sat Mar 28 06:59:03 EDT 2015 | robertwillis
I would agree with the comments so far its much better to have some pre heat. You have not explained why bottom side preheat is a problem. Even having some input will help balance the process. Assume there is some thing on the back side that is a pro
Electronics Forum | Thu Feb 26 08:44:38 EST 2015 | spoiltforchoice
...Unless you could dispense a fine glassfibre mesh in much the same way a 3D printer extrudes plastic filament and then spray epoxy over the top. It would be remiss to 2nd guess what compounds physical chemists can come up with for such a project. E
Electronics Forum | Fri May 22 20:50:55 EDT 2015 | jlawson
Siemens FX may have some good parts in MES part but front end and NPI tools are much more limited to what Valor MSS offers... As total package end to end Valor MSS can provide full scope. Siemens has not put much R&D and enhancements in front end 'U
Electronics Forum | Tue Apr 11 13:01:36 EDT 2017 | mrich208
Yes Sir, someone had replaced the fuse with a resistor and it had burned up. We had an exact board on the VCD. We swapped them and it worked! I am not sure how this forum works but now the machine will zero and say it's missing a part but the sequ
Electronics Forum | Wed Jul 12 08:49:38 EDT 2017 | williamaxler
I have a few LED pcb's that have an aluminum > substrate that are ridiculous to rework. They > heat-sink like crazy and I can't reflow the bad > LED's, no matter how much heat I apply. Any > suggestions on techniques or equipment to use? > I ha
Electronics Forum | Mon Oct 29 12:44:33 EDT 2018 | robl
Hi Reckless, If it's a Standard Phillips Sapphire then no, they are not a beginner machine. The feeders have to be spot on and the machine requires a much longer service as they have 2 sets of 12 heads. Spares will start becoming harder to get soon
.gif)
