Electronics Forum | Sun Jan 28 03:36:53 EST 2007 | sami
hi to all. I am new in this forums. but I like it too much. i am working on universal machine but sometimes i had a problem when the CAD data ( X,Y,Theta ) information are not correct, I adjust them manually in Board Enhanced Setup, my question is th
Electronics Forum | Sun Jan 28 22:03:22 EST 2007 | dave
ca anyone help i need to design a circuit which can deliver 18v from 24v the problem is that the "extra" 6v i dont just wanna lose as heat/or lost energy as I have a limited power supply is there an effective way to do this - i have basic el
Electronics Forum | Wed Jan 31 05:23:37 EST 2007 | pbarton
Barry, We do not see much in the way of solder splatter or solder balling. We have removed some parts but in the process of doing so we remove any useful evidence really. Quite a lot of the solderable portion of the part is on the underside. Like
Electronics Forum | Wed Feb 07 09:37:48 EST 2007 | billyd
Had the very same thing happen the first time we used the small QFNs. The aperture for the thermal pad in the center needs to be cut in a grid form, either squares (with around a 10 mil spacing between openings) or circles, like a BGA pattern. Too mu
Electronics Forum | Tue Feb 13 14:33:16 EST 2007 | CK the Flip
So the moral of the story is..... these SAC305 BGA's were accidentally mixed in with a Leaded process, the profile couldn't get hot enough due to Tg and Td constraints on a known good QFP on the same board, and consequently, the whole assembly fail
Electronics Forum | Wed Feb 14 14:11:17 EST 2007 | greg york
We have profiled hundreds of ovens here and it really is dependent on work going through, I walked in on one trial and was faced with an oven that was literally two foot long and told the guy it would not be suited only to profile and run lead free t
Electronics Forum | Wed Feb 21 09:52:56 EST 2007 | SMTRework
Hello everyone, I'm wondering if anyone knows of an automatic BGA reballing unit / system? I'm aware of the "martin" / Manncorp" unit but was looking for info on other manufacturers of this type of device. I usually need to reball about 10 pcs at
Electronics Forum | Tue Feb 27 12:45:08 EST 2007 | russ
Boy it is good to see the wave master back in action! I mean really guys, is Larry the only one here who knows that the lead turns into vapor in the oven and then in the cooling zones it falls back onto the board and creates the solder joints? P.
Electronics Forum | Tue Mar 06 15:23:10 EST 2007 | mmjm_1099
All, I have hix mix and medium to low volume. Alot of the orders are the same monthly by quantity and product. I have gone through and optimized as much as I can. I have orders to justify equipment as well. I want to accomplish more output of product
Electronics Forum | Fri Mar 16 15:39:05 EDT 2007 | fastek
Craig- Pretty much every equipment vendor is guilty of what Assembleon did to you. When they think you are committed to their platform OR you are small potatoes to them.....they will hammer you on pricing. It's always been that way and they all do i