Electronics Forum | Fri Sep 23 10:28:43 EDT 2011 | minda
A big customer for controller cards is complaining about the quality of the soldering on our PCBs. The photographs they sent were very unreasonable, pointing out minor defects such as tiny (tiny as in smaller than the point of a pin) drips of solder
Electronics Forum | Thu Oct 20 19:35:45 EDT 2011 | eadthem
Your kinda vague on your description, How many components per hour, how many circuits per a day, week, month? what kinds and size of parts.? For a PNP setup for smt boards you will need a stencil printer(possibly manual or full auto like a DEK, 1 o
Electronics Forum | Wed Oct 26 20:20:28 EDT 2011 | machinehead
Our Company is suffering a Huge lose in scrap parts. I recently took over the My12 MyData SMT Machine. And I'm trying to find a remedy to the lose of exposed parts when pulling tape out of feeders. I've tryed alot of things? But still no Luck. I'm lo
Electronics Forum | Mon Oct 31 18:18:21 EDT 2011 | conjugate
Thanks a lot. I`ve been doing a research for existing products as well and yes Teknek is quite helpful. Now I need to do some simulation analysis, collect some data and compare with manual operation in order to proof that this is a good and strong pr
Electronics Forum | Mon Apr 30 13:45:11 EDT 2012 | rway
JimnHky is pretty much spot on. We have a high mix low volume line of products (most anyways). We have experimented with lean quite a bit, and have achieved single piece flow on our most voluminous product. In fact, this is where I would recommend
Electronics Forum | Fri Nov 18 11:51:47 EST 2011 | rway
Much ado about nothing. Reminding has failed? Who runs the place? You sound like you are a person in authority. You may not be the boss, but authority has weight. The folks that can't seem to remember (or care to remember) have bosses that you c
Electronics Forum | Wed Dec 14 22:13:00 EST 2011 | deanm
I would first check the moisture barrier bag that the parts come in. There is a label showing the MSL level on the bag and sometimes included with the information on the reel. Transfer this info to your MRP system. If your receiving department throws
Electronics Forum | Fri Mar 09 04:10:18 EST 2012 | grahamcooper22
Hi, I've been supplying Totech dry cabinets in the Uk for 10 years and in that time I've realised the only places to find the correct MSL level is on the dry pack the devices are shipped in or by spending hours on the internet or speaking to the devi
Electronics Forum | Tue Jan 10 19:01:13 EST 2012 | carvincorp
I was wondering if anyone else out there using the Vectorguard system by DEK has had problems with leaking air bladders. We started using a 29 x 29 frame about a year ago, and already, we've needed to send the frame back 3 times for repair due to int
Electronics Forum | Thu Jan 19 09:41:47 EST 2012 | charliedci
We have the same issues with QFN's on reels being cost prohibitive, so we also have to deal with tubes. We have had some luck with using a modified tube ran down (almost to the pick position) the channel of a belt feeder, assuming the QFN tube/channe