Electronics Forum | Mon Sep 06 08:05:51 EDT 1999 | stefano bolleri
| We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji doe
Electronics Forum | Wed Sep 08 23:36:12 EDT 1999 | Jason Tomlinson
| | | Dear all, | | | | | | I don't know if I'm asking at the right place here, since you all seem to be more focused on process problems then programming problems (or perhaps programming isn't a problem for you). | | | | | | I'm using FUJI CP642's
Electronics Forum | Thu Aug 05 12:20:06 EDT 1999 | John Thorup
| | | | | | | | | | | | | | | Hello, | | | | If you are using no-clean and they are entrapped in the flux it is also IPC accepted but i havent found a customer yet who agrees with that. Im sure you have checked your profile. I had the same problem
Electronics Forum | Sat Aug 07 11:47:47 EDT 1999 | JohnW
| | | | | | | | | | | | Hello, | | | If you are using no-clean and they are entrapped in the flux it is also IPC accepted but i havent found a customer yet who agrees with that. Im sure you have checked your profile. I had the same problem with chi
Electronics Forum | Thu Jul 29 15:35:05 EDT 1999 | Earl Moon
| | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That wou
Electronics Forum | Tue Jul 27 14:56:23 EDT 1999 | John Thorup
| | | | We are currently using a 65/35 solder for our wave process but are considering switching to a 63/37 for a substantial cost savings. No one here seems to know why we everused a 65/35 formulation in the first place. | | | | I understand 63/37 t
Electronics Forum | Tue Jul 27 16:44:31 EDT 1999 | Earl Moon
| | | Presently protos of micro-bgas (80i/o) pitch .030/.031 | | | 12BGA per assembly | | | | | | The board is a (.062, 4 layers) FR-4 using Dry film | | | Pads .014inch | | | Vias within footprint .020inch | | | Vias to be filled by bottom side(sol
Electronics Forum | Tue Jul 27 17:23:45 EDT 1999 | M.L
| | | | Presently protos of micro-bgas (80i/o) pitch .030/.031 | | | | 12BGA per assembly | | | | | | | | The board is a (.062, 4 layers) FR-4 using Dry film | | | | Pads .014inch | | | | Vias within footprint .020inch | | | | Vias to be filled by b
Electronics Forum | Sat Jul 17 03:02:58 EDT 1999 | Jeff Sanchez
| | | | | I need a good chemical to remove the lacquer finish off of magnet wire. I know there are different kinds but I need one that really works. Any suggestions would be great. thanks in advance guys. | | | | | | | | | What is it you're trying t
Electronics Forum | Thu Jul 15 14:55:24 EDT 1999 | JohnW
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa