Electronics Forum | Wed Jun 03 18:22:19 EDT 1998 | Chrys
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Wed Jun 03 21:40:38 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Wed Jun 03 09:04:19 EDT 1998 | Steve Gregory
Hi Anthony! Earl's right, things can get rather involved when you start discussing ALL the things that affect whether or not a board is going to warp. The way I look at the issue is try to separate the warp issue into two catagories; 1. The board bei
Electronics Forum | Wed Jun 03 01:06:13 EDT 1998 | Mike Moninger
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Wed May 27 14:20:43 EDT 1998 | Earl Moon
| We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized to
Electronics Forum | Fri May 29 17:07:00 EDT 1998 | Dave F
| | We recently made the switch to no-clean and the wurface mount is turning out beautifully. However, the wave solder process continues to put up a fight; we are getting a white residue on the surface of the PCB. The residue is not localized
Electronics Forum | Tue May 26 14:42:55 EDT 1998 | Justin Medernach
| We currently bake plastic SMT parts in accordance with the IPC guidelines for moisture sensitive parts. Because we have double-sided boards that are subjected to either an aqueous or semi-aqueous cleaning process, we do a 24 hour bake at 125 deg.
Electronics Forum | Fri May 22 16:08:05 EDT 1998 | Steve Gregory
Hi ya' Mike! For low temperature baking, IPC-SM-786A (Procedures for Characterizing and Handling of Moisture/Reflow Sensitive IC's) specifies a low temperature bake that can be done in the component shipping packaging...ya' wanna remove the bubb
Electronics Forum | Mon May 18 20:57:06 EDT 1998 | Earl Moon
.025" pitch so the only problem we run into is too much HASL on the adhesive side causing improper glue dispense. | As Earl keeps saying HASL thickness is hard to impossible to control. I think we need to look hard at OSP's again but then you get in
Electronics Forum | Mon May 18 22:54:04 EDT 1998 | Dave F
.025" pitch so the only problem we run into is too much HASL on the adhesive side causing improper glue dispense. | | As Earl keeps saying HASL thickness is hard to impossible to control. I think we need to look hard at OSP's again but then you get
