Electronics Forum | Wed Sep 29 14:41:43 EDT 1999 | Earl Moon
| Guys thanks so much for your help I did'nt realize | how much feedback I was going to get. I am going to | take your advice and do a little more equipment | research and try and find the best offer I can get | without sacrificing equipment needs.A
Electronics Forum | Thu Sep 23 10:37:06 EDT 1999 | Dave F
| Hiya, | | Could anyone please suggest recommended manufacturers of | IR rework stations for the removal of various SMT comps. | | Cheers | Hey Jack: Let's not get lost. The issue is money versus process control. How much do you have versus h
Electronics Forum | Tue Sep 07 06:49:18 EDT 1999 | stefano bolleri
| | | I agree SB..Fuji feeders rarely get off that much.Are you using | the Auto-Offset function in your Part data?This will | usually keep your pick on Cp's humming! | YES, always use the auto-offset function in each part data (do you also need t
Electronics Forum | Thu Aug 05 10:55:09 EDT 1999 | Wolfgang Busko
| | | | | | Hello, | If you are using no-clean and they are entrapped in the flux it is also IPC accepted but i havent found a customer yet who agrees with that. Im sure you have checked your profile. I had the same problem with chip components but
Electronics Forum | Thu Jul 15 14:18:24 EDT 1999 | Gord Wait
I'm designing a board where the parts will only fit if I do one of the following: 1. Put BGAs on both sides 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA parts. Can
Electronics Forum | Thu Jul 15 15:41:00 EDT 1999 | Doug
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Thu Jul 15 16:59:57 EDT 1999 | Glenn Robertson
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Thu Jul 15 21:18:27 EDT 1999 | Scott McKee
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Thu Jun 03 16:12:24 EDT 1999 | Earl Moon
.020" pitch spacing. Which have yielded my process excelent results. | My main stencil supplier is I-Source in Irvine, CA and has pretty much standardized on 100% lazer cut stencils for competetive pricing. | Hope this helps. | | Deon Nungaray | SM
Electronics Forum | Thu May 27 12:19:35 EDT 1999 | Clifford Peaslee
Hello Smtneters, Due to the intolerable performance of the server that SMTnet currenlty resides, we have initiated a move to a new server (Dual PIII 550, 512Meg). There will be a down time, but we are not sure exactly how long it will be. I suspect
.gif)
