Electronics Forum | Tue Apr 08 04:40:43 EDT 2008 | fnorradd
Hi, just wonder if anyone has any recommendations of where i can find spare parts for the adjustable PCB workboard holders ie, clamps, support arms and spring loaded supports etc. Basically looking for everything apart from main plate. Any details
Electronics Forum | Wed Apr 09 03:21:36 EDT 2008 | fnorradd
Hi Steve, The adjustable workboard holders are a mixture of universal and aftermarket, they do not use the clamp down arms which were originally with the universal pbs holders, they are the type which have two grub screws holding the clamps to the h
Electronics Forum | Mon Jun 08 09:20:57 EDT 2020 | vinitverma
Since it is an Emerald XII, I suppose it is Windows and not VIOS. Go to Optimize and select "Convert with Note Data". This will convert all blocks to single PCB and keep a NOTE of original Block Data so that you can convert back to block if and when
Electronics Forum | Sat Nov 01 04:12:53 EDT 2008 | ashley
Hello mickd, The Fiducial Marks are normally etched along the vertical side of the PCB, therefore it will not be block by the XY table clamping rails. p.s. try to have a Shiny & Round Fiducial Mark as recommended by Fuji....so that you need not inp
Electronics Forum | Fri Aug 06 10:06:34 EDT 1999 | Peter Brant
| | | I need to find quality benchtop develop, strip, & etch equipment. | | | Any ideas? | | try LPKF in Beaverton, Or. 503/634-0604 or the link below. I haven't used their eq so this is not an endorsement | | John Thorup | | let's try that link a
Electronics Forum | Wed Aug 02 23:28:44 EDT 2017 | dawson
there are many ideal pcb manufacturers can reach your requirements. multi-layer and hdi boards, you can try and test http://www.madpcb.com
Electronics Forum | Sat Oct 10 12:14:45 EDT 2020 | krishna7185
I woud like to ask is there any command in Alitum Designer 17.0 which will help to group component circuit wise while we provide netlist to pcb from schematic. Actually i have single page schematic with many circuits on it block wise like GPS, RF, Po
Electronics Forum | Tue Aug 31 07:51:28 EDT 2004 | dennispoquiz
I used to do optimization on Panasert MV2F/V,Fuji CP6/4,GSM (Universal),Sanyo TCM 3000 with no problem. My problem now is on my old Sanyo V822 SMT chipshooter. I am working on a multi-block (multi-cavity) PCB panel and i cannot, in any way, mount all
Electronics Forum | Fri Apr 06 04:10:25 EDT 2001 | kensmoke
We recently had a multi block panal change at the vendor Now the production lines are producing solderability defects in great number. The makeup of the pcb is a type of fiber glass mask green in color and pads with no tinning just copper lands.
Electronics Forum | Fri May 07 22:27:41 EDT 1999 | Big K
My company has a product line that utilizes multi-up PCB's. In order to cut costs for this product line, I have been asked to look into ways of running panels that contain bad blocks. Our SMT equipment is quite capable of doing this, but I need to k
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
