Electronics Forum | Wed Feb 01 18:10:03 EST 2006 | HN
I'm using Fuji Flexa with ip3 and cp65, can I get the parts data file? my mail is hai.hnguyen@sanmina-sci.com. thanks
Electronics Forum | Sun Aug 14 22:58:17 EDT 2005 | crishan
Hi All, I would like help in establishing what is a feasible PPM reject rate from a typical SMD line. As a reference an SMD line consists of, solder paste printer, chip component placement, pick and place IC components and reflow. What is a bench
Electronics Forum | Fri Jul 08 10:45:17 EDT 2005 | dougs
Jack, Your telling me to do what i wanted to do anyway, My first question on the thread was where do i get this type of software.
Electronics Forum | Thu May 26 15:28:41 EDT 2005 | jh0n!
It looks like there's another one or two threads somewhat similar, but allow me to pose another. We've only about two years experience in SMD production, and we're just starting to really ramp-up. As we stand right now, I'm not recieving informatio
Electronics Forum | Wed Jul 06 09:51:23 EDT 2005 | Jack
Doug, It always seems easier to fix one or two problems by eye at the time. The real problem comes when the customer wants the same board run again later. You're okay if you saved the corrected placement routine, but if you end up moving the job t
Electronics Forum | Thu May 26 19:29:35 EDT 2005 | jh0n!
Yeah - I can handle most scripting/programming - but I'm completely unfamiliar with this side of these machines. For example, when looking at the Aegis software, they're tracking real-time defects, etc....That's what I'm curious about there - how to
Electronics Forum | Tue Jan 31 18:50:01 EST 2023 | markhoch
You might want to look into the Vorne XL Productivity Appliance. You connect it to your line by connecting it to a sensor that will trigger an input. (I used the exit sensor on the pre-reflow conveyor). It's probably the most cost effective productiv
Electronics Forum | Sun Sep 12 09:40:04 EDT 1999 | Wayne S.
hello having a problem with one customers bare boards not matching my stencil apertures. i design stencils based on gerber data and reduce up to 15% on some pads. do some board houses reduce pads after receiving gerber data???why would they do that
Electronics Forum | Fri Aug 02 12:03:00 EDT 2024 | spoiltforchoice
For a while at least a typo on the URL revealed there was at least a trial installation of an alternative forum software, some delay and hoops to jump through should kill the worst spam. I will edit my earlier post with an attachment of some kind at
Electronics Forum | Tue Jul 30 09:05:08 EDT 2024 | spoiltforchoice
SMT Maestro is long gone from the wider web. You have to beg those of us who have a copy to share a link or find one of the previously shared links in this forum and see if it is still active. Technically this basic requirement is not that difficult