Electronics Forum | Wed Mar 08 16:52:07 EST 2006 | darby
Which model Yamhah are you talking about and what is the make and model # of the manifold block for the micro ejectors? If it has the Koganei ME05M series then your local rep can supply the filters. It is a good idea to get spare O-rings for the filt
Electronics Forum | Wed Oct 23 02:45:17 EDT 2019 | maxwilko
Hello there, My 'MyChronic MyData My500 Solder Jet printer' keeps having the same issue and I am unable to solve the issue. Suction flow too low: Check filter box and suction holes are clear. This problem would usually be solved by a new filter bo
Electronics Forum | Sat May 29 13:53:18 EDT 2010 | jandon
MY500 minimum dot diameter is 0.33 mm (0.013”) so you still need stencil for smaller dots. You are liable to couple of jet printing solder paste manufacturer and there where I live, only official Mydata distributor can sell those solder pastes. Also
Electronics Forum | Wed Mar 02 02:07:06 EST 2016 | mbass
3000 components per side and yes the actual print cycle is longer (13 minutes) against the DEK print stroke of 30 seconds. But overall the whole cycle time of set up etc is way less on the MY500. The ability of the machine to adjust volume of paste o
Electronics Forum | Mon Mar 07 09:23:25 EST 2016 | rgduval
We've had our My500 for about four months now, and couldn't be happier. We are a super-high-mix, super-low-volume shop, and the flexibility provided by the 500 over stencils is stunning. So, you buy 5-10 stencils a week? That's 260-520 stencils a
| 1 |
.jpg)
