Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Fri Feb 15 15:09:24 EST 2008 | soudomphong
Anybody have any idea where to get the cutter motor for siplace 80-S20 with reasonable price? I am also looking for S20 head board, and a Y-axis motor. Any help would be much appreciated, thank you.
Electronics Forum | Sun Jun 12 01:38:47 EDT 2022 | mikevb
I'm having a problem with my Mydata My9 pick and place. Basically whenever I try to run the placement calibration program or try to have the machine find fiducials, or basically anything with precision, the machine displays a X MOT motor timeout erro
Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Tue Jun 14 16:23:22 EDT 2022 | glasscake
Cant put a finger on it being an encoder that was just a single possibility. You can always hook up a scope to the encoder and see if they are working appropriately. I would look through the machine's utilities and see if there is some debug or more
Electronics Forum | Wed Jan 29 13:01:04 EST 2014 | tech1
Back when the Linear Y wagons first came out Mydata had problem with the original Y amplifier and were swapping out the complete box for customers who had problems. There was also a problem with the encoder that resulted in the same type of errors yo
.gif)
