Electronics Forum | Mon Oct 29 15:41:08 EDT 2012 | mbnetto
Hello, Here in our factory we have a line with 3 mydatas MY9 in series. I'm trying to do a optimization of a new product but I'm facing some problems. I noticed that after the optimization the software is considering all the components that use onl
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Thu Feb 20 14:02:31 EST 2014 | rgduval
I'm in the market for some new (to me) pick and place equipment, and, could use some opinions. I'm a MyData guy by experience, and have recently been working on some older Philips machines. I'm comfortable on a MyData platform due to experience,
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Mon Sep 15 14:14:47 EDT 2014 | riot983
Hi guys, New to the forum. I always read and look around at used equipment but have never posted. Anyway, I operate a Mydata My9 at a small shop and have recently ran into a problem and wanted to get some good advice. An employee of mine cleaned the
Electronics Forum | Mon Nov 10 09:11:51 EST 2014 | rgduval
The centering jaws are made out of copper, I believe...and conductive. I'd suggest that the conductivity of the copper makes it a fairly poor source of ESD damage in a component. I have observed physical damage to components from the centering jaws
Electronics Forum | Mon Jun 15 17:54:38 EDT 2015 | catsem23
Hi I have been having a problem with my Hydra tool reference plate. Machine keeps stopping and comes up with error message - failed to locate hydra tool reference marks & Error mounting component .... from feeder ..... with nozzle .... I have check
Electronics Forum | Fri Sep 18 13:11:38 EDT 2015 | dyoungquist
We used to run a TP9-2 but upgraded to the MY series about 5 years ago..... Encoder going bad is a likely possibility, especially on a machine that old. I can't say for sure that is your problem but we did have to replace an encoder on our TP9 (I
Electronics Forum | Fri Sep 09 05:42:43 EDT 2016 | jasltd
Hi folks, I'm looking for definitions on the categories from the Management reporting from MYData's (running My9 & MY19 machines TPSYS 2.4) I'd like to understand what the machine classifies into the following: Up time Active Time Run Time I"m buil