Electronics Forum | Wed Oct 23 02:08:21 EDT 2019 | bukas
sounds like bad electrolytic capacitor, check if your drivers have any swollen capacitors or otherwise damaged caps
Electronics Forum | Thu Nov 15 19:56:18 EST 2012 | rgduval
I would have said it sounded like a motor/encoder problem...but, since you found the broken resistor, that was likely the source of your issue. The resistor and capacitor are a filter for the motor, MyData likes to put them on nearly all of the moto
Electronics Forum | Thu Mar 08 16:17:59 EST 2007 | stepheniii
Your process makes a bigger difference than the machine. I worked for and OEM with Panasonics. They eliminated all 5% resistors, wider tolerance capacitors, and went with as many dedicated feeders as we could. We also staged jobs. We had one runnin
Electronics Forum | Fri Dec 30 09:37:53 EST 2016 | dyoungquist
Package screen and select the package you have programmed for the capacitor. Next press F3 to edit accelerations. In the popup screen set the X and both Hydras to low or lowest. That should accomplish the slow motion you are after.
Electronics Forum | Fri Oct 29 17:48:46 EDT 2021 | artem
Hello, I have found the problem. The capacitors on the PAIB board were leaking. They have even demaged some traces and vias on the PCB and the -5V supply on the PAIB board was not working anymore. Got it working again :)
Electronics Forum | Sun Oct 24 08:07:06 EDT 2021 | artem
Hello, I have a Mydata TP11-UFP which stopped working. It prints F-MOT1-38/245:MSETDYNX during initialisation. Any idea what could be wrong? I have already replaced the capacitors and the Inrush Current Limiters on the "L-19-588-18" board. Also ins
Electronics Forum | Wed Feb 25 15:16:56 EST 2015 | dyoungquist
We have MY12 and MY15E machines. I am going to assume what we are seeing also applies to the MY100 series machines as well. Do you have the electrical verifier option that works with the midas head and centering jaws to check component values of
Electronics Forum | Wed Nov 09 12:06:33 EST 2005 | Rob
I don't want to throw a spanner in the works here, but a large proportion of chip resistors & capacitors have been ROHS compliant for a couple of years now, the manufacturers have just not declaired it. Could it be that the part you have just has
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
Electronics Forum | Wed Apr 28 20:57:22 EDT 2021 | stephendo
It will be tough to get a good line for that cost. You might want to start by looking at Mydata and Juki for the machines. Ekra for the screen printer and Heller for the oven is where you might want to start. If you have not already you might want
| 1 |
