Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Thu Jan 07 18:34:51 EST 2021 | tamcrocker
Hello, I have an UMG VCD-H that is currently stop working due to a message " head Zero switch error" when retracting. I would like to know how to clear this message.
Electronics Forum | Thu Mar 31 16:05:22 EDT 2011 | tiffconw
I have older Multitroniks that I am working with. I get error message " can not get retry value" and it locks up machine till I re-boot. I cannot find referance to message in book, anyone know this fix ? Also other problems if any Multroniks people o
Electronics Forum | Mon Jan 18 12:20:28 EST 2021 | tamcrocker
Thank you for the respond, will check out the switch and give the Alpha 1 Technologies a call if the switch is not the problem.
Electronics Forum | Fri Jan 15 12:20:26 EST 2021 | proceng1
It sounds like the homing switch isn't being made when it zeros. Alpha 1 Technologies can probably help. 607-772-2900 That's who we call for VCD issues.
Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Tue Feb 11 14:42:49 EST 2014 | rdubya
Centering motor about to fail or has failed.
Electronics Forum | Tue Feb 18 21:16:49 EST 2014 | brendansales
Thank you Sir, I'll go check it out.
